mpc82x54a Megawin Technology, mpc82x54a Datasheet - Page 18

• Manufacturer Part Number: mpc82x54a
• Description: 8-bit Micro-controller
• Manufacturer: Megawin Technology

18
NVM register: OR3 (Option Register 3):
reserved1:= The bit is reserved for afterward user, and should be left at set.
OSCDN: = Used to adjust the behavior of crystal oscillator.
HWBS2:= Used to adjust the behavior of crystal oscillator.
ENROSC: = Used to determined if to enable the built-in RC oscillator.
HWENW: = Hardware Enable Watch-dog-timer
HWWIDL: = Hardware enables reset from Watch-dog-timer in spite of the MCU lies idle.
reserved1
The user must not clear the bit; otherwise, there could be inadvertent effect impacted on the
device.
The user must not clear the bit; otherwise, there could be inadvertent effect impacted on the
device.
Bit-7
If the bit HWENW is left 1, the bits HWWIDL, HWPS2, HWPS1 and HWPS0 make no sense.
If the bit HWENW is cleared to 0, those bits will be loaded into SFR WDTCR after power-up.
Those three bits set the pre-scalar of the watch-dog-timer.
If the bit HWENW is left 1, those three bits makes no sense.
{HWPS2, HWPS1, HWPS0}:= Hardware Watch-dog-timer Pre-Scalar
0:=
1:= (default)
0:=
1:= (default)
0:=
1:= (default)
0:=
1:= (default)
0:=
Watch-dog-timer is also suspended while the MCU lies idle.
1:= (default)
{0,0,0}:=
{0,0,1}:=
Enable watch-dog-timer to keep working in spite of the MCU has been put into idle mode.
The current gain of crystal oscillator amplifier is reduced. It will bring
help to EMI reducing and improve the power consumption. Dealing with application does
not need high frequency clock (under 12MHz). It is recommended to do so.
The current gain of crystal oscillator is enough for oscillator to start oscillating up to 24MHz.
Force the boot entrance as ISP code for both of power-up boot and RST-pin boot.
Transfer the determination of boot entrance to HWBS.
Clearing the bit will enable the built-in RC oscillator, and set that oscillator as the oscillating
source
Setting the bit means to disable the built-in RC oscillator.
Clearing the bit will automatically enable the watch-dog-timer after power-up immediately.
HWWIDL, HWPS2, HWPS1 and HWPS0 will be loaded Into SFR WDTCR after power-up if
and only if HWENW =0.
No Hardware enable for Watch-dog-timer.
The frequency of the clock source for the watch-dog-timer is divided by 2.
The frequency of the clock source for the watch-dog-timer is divided by 4.
By using HWBS2, ISP program may be triggered to run by RESET pin. (See Boot and
Reset section)
reserved1
Bit-6
HWENW
Bit-5
MPC82x54A Data Sheet
Bit-4
-
HWWIDL
Bit-3
HWPS2
Bit-2
HWPS1
Bit-1
MEGAWIN
HWPS0
Bit-0