lan9303m Standard Microsystems Corp., lan9303m Datasheet - Page 137

• Manufacturer Part Number: lan9303m
• Description: Small Form Factor Three Port 10/100 Managed Ethernet Switch With Dual Mii/rmii/turbo Mii
• Manufacturer: Standard Microsystems Corp.

Small Form Factor Three Port 10/100 Managed Ethernet Switch with Dual MII/RMII/Turbo MII
Datasheet
SMSC LAN9303M/LAN9303Mi
10.4
10.4.1
The MII mode multiplexer is used to direct the MII data/management path connections. One master
(MAC via the MII pins, or PMI) is connected to the slaves (PHY via MII pins, Port 1/2 PHYs, Virtual
PHY, and SMI slave) dependant on the selected management mode of the device. The MII mode
multiplexer also performs the multiplexing of the read data signals from the slaves and controls the
output enable of the MII pins.
The following sections detail the operation of the MII mode multiplexer in each management mode. A
list of management modes and their configuration settings are discussed in
Operation," on page
Port 0 MAC Mode SMI Managed
In Port 0 MAC mode SMI managed, the internal PHYs and SMI slave block are accessed via the MII
management pins. The Virtual PHY and PMI are not used in this mode.
The Virtual PHY interface is accessible via the SMI slave or the EEPROM Loader. Refer to
10.2, "SMI Slave Controller," on page 134
additional information.
Figure 10.1
MII Mode Multiplexer
Figure 10.1 MII Mux Management Path Connections - MAC Mode SMI Managed
MDI
MDCLK
MDI
MDCLK
MDI
MDCLK
MDI
MDCLK
Virtual PHY
SMI Slave
details the MII multiplexer management path connections for this mode.
Mode Selection
PHY2
PHY1
Management
Parallel
Parallel
Master
Slave
MDIO_ DIR
MDIO_ DIR
MDIO_ DIR
MDIO_ DIR
MDO
MDO
MDO
MDO
19.
DATASHEET
137
Mode Selection
Management
and
Section 8.4, "EEPROM Loader," on page 120
MDO MDCLK
Parallel Slave
PMI
MDI
MDO_EnN
MDO
MDI
MDC_DIR
MDC_ OUT
MDC_IN
MDIO_DIR
MII Pins
Section 2.3, "Modes of
Revision 1.3 (08-27-09)
MDIO
MDC
Section
for