lan9211 Standard Microsystems Corp., lan9211 Datasheet - Page 18

no-image

lan9211

Manufacturer Part Number
lan9211
Description
Lan9211 High-performance Small Form Factor Single-chip Ethernet Controller With Hp Auto-mdix Support
Manufacturer
Standard Microsystems Corp.
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
lan9211-ABZJ
Manufacturer:
Standard
Quantity:
3
Part Number:
lan9211-ABZJ
Manufacturer:
SMSC
Quantity:
1 154
Part Number:
lan9211-ABZJ
Manufacturer:
SMSC
Quantity:
20 000
Revision 2.3 (08-06-08)
Activity Indicator),
Common Ground
General Purpose
+3.3V I/O Power
nLED1 (Speed
nLED2 (Link &
nLED3 (Full-
+3.3V Analog
+1.8V Analog
Core Voltage
Decoupling
Indicator
Indicator),
I/O data,
Duplex
NAME
Power
Power
Note 2.1
).
VDD_CORE
Please refer to the SMSC application note AN16.6 - “Migrating from LAN9215 to the
LAN9210/LAN9211” for additional details.
GPIO[2:0]/
nLED[3:1]
VDD_A33
VDD_A18
SYMBOL
VDD_IO
VSS
Table 2.4 System and Power Signals (continued)
BUFFER
IS/O12/
TYPE
OD12
P
P
P
P
P
DATASHEET
High-Performance Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX Support
18
1 pad
NUM
PINS
3
5
3
1
2
General Purpose I/O data: These three
general-purpose signals are fully programmable
as either push-pull output, open-drain output or
input by writing the GPIO_CFG configuration
register in the CSR’s. They are also multiplexed
as GP LED connections.
GPIO signals are Schmitt-triggered inputs.
When configured as LED outputs these signals
are open-drain.
nLED1 (Speed Indicator). This signal is driven
low when the operating speed is 100Mbs,
during auto-negotiation and when the cable is
disconnected. This signal is driven high only
during 10Mbs operation.
nLED2 (Link & Activity Indicator). This signal
is driven low (LED on) when the LAN9211
detects a valid link. This signal is pulsed high
(LED off) for 80mS whenever transmit or
receive activity is detected. This signal is then
driven low again for a minimum of 80mS, after
which time it will repeat the process if TX or RX
activity is detected. Effectively, LED2 is
activated solid for a link. When transmit or
receive activity is sensed LED2 will flash as an
activity indicator.
nLED3 (Full-Duplex Indicator). This signal is
driven low when the link is operating in full-
duplex mode.
+3.3V I/O logic power supply pins
Common Ground
+3.3V analog power supply pins. See
+1.8V analog power supply pin. This pin must
be connected externally to VDD_CORE. See
Note
+1.8 V from internal core regulator. Both pins
must be connected together externally. Each
pin requires a 0.01uF decoupling capacitor. In
addition, pin 2 requires a bulk 4.7uF capacitor
(<2 Ohm ESR) in parallel. These pins must not
be used to supply power to other external
devices. See
2.1.
Note
DESCRIPTION
2.1.
SMSC LAN9211
Note
Datasheet
2.1.

Related parts for lan9211