lan9211 Standard Microsystems Corp., lan9211 Datasheet - Page 38

• Manufacturer Part Number: lan9211
• Description: Lan9211 High-performance Small Form Factor Single-chip Ethernet Controller With Hp Auto-mdix Support
• Manufacturer: Standard Microsystems Corp.

Revision 2.3 (08-06-08)
3.9.2.1
If an operation is attempted, and an EEPROM device does not respond within 30mS, the LAN9211
will timeout, and the EPC timeout bit (EPC_TO) in the E2P_CMD register will be set.
Figure 3.4, "EEPROM Access Flow Diagram"
EEPROM Read or Write operation.
The host can disable the EEPROM interface through the GPIO_CFG register. When the interface is
disabled, the EEDIO and ECLK signals can be used as general-purpose outputs, or they may be used
to monitor internal MII signals.
Supported EEPROM Operations
The EEPROM controller supports the following EEPROM operations under host control via the
E2P_CMD register. The operations are commonly supported by “93C46” EEPROM devices. A
description and functional timing diagram is provided below for each operation. Please refer to the
E2P_CMD register description in
page 101
Busy Bit = 0
for E2P_CMD field settings for each command.
EEPROM Write
Figure 3.4 EEPROM Access Flow Diagram
Write Data
Command
Command
Register
Register
Register
Write
Read
Idle
DATASHEET
Section 5.3.23, "E2P_CMD – EEPROM Command Register," on
High-Performance Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX Support
38
illustrates the host accesses required to perform an
EEPROM Read
Read Data
Command
Command
Register
Register
Register
Write
Read
Idle
Busy Bit = 0
SMSC LAN9211
Datasheet