mic3003gfltr Micrel Semiconductor, mic3003gfltr Datasheet - Page 61

• Manufacturer Part Number: mic3003gfltr
• Description: Fom Management Ic With Internal Calibration
• Manufacturer: Micrel Semiconductor

Micrel, Inc.
July 2010
Default value for all bytes
Serial address
Byte addresses
This four-byte field is the password required for access to the OEM area of the MIC3003’s memory and registers. This field is
compared to the four-byte OEMPW field at serial address A2 h . If the two fields match, access is allowed to the OEM areas of
the MIC3003 non-volatile memory at serial addresses A4 h and A6 h .
The OEM password may be set by writing the new value into OEMPWSET. The new password will not take effect until after a
power-on reset occurs or a warm reset is performed using the RST bit in OEMCFG0. This allows the new password to be
verified before it takes effect.
These registers are non-volatile and will be maintained through power and reset cycles. A valid OEM password is required for
access to this register.
Byte
3
2
1
0
Default value
Serial address
Byte address
A valid OEM password is required for access to this register. This register is volatile and will not keep its value through power
cycles.
read-only
reserved
read/write
D[7]
D[7]
Weight
OEM Password, Most Significant Byte
OEM Password, 2nd Most Significant Byte
OEM Password, 2nd Least Significant Byte
OEM Password, Least Significant Byte
read/write
FLTDIS
read/write
D[6]
D[6]
read/write
read/write
FSPIN
D[5]
D[5]
OEM Password Setting (OEMPWSET)
OEM Calibration 0 (OEMCAL0)
0000 0000 b = 00 h
A6 h
12 - 15 = 0C h - 0F h
0000 0000 b = 00 h
A6 h
16 = 10 h
read/write
read/write
WRINH
D[4]
D[4]
read/write
read/write
APCCAL
61
D[3]
D[3]
read/write
read-only
reserved
D[2]
D[2]
[e-mail]
read/write
read-only
reserved
D[1]
D[1]
or [phone]
read/write
read/write
FRCOPS
M9999-072910-A
MIC3003GFL
D[0]
D[0]