tda5144t NXP Semiconductors, tda5144t Datasheet - Page 14
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
tda5144t
Manufacturer Part Number
tda5144t
Description
Brushless Dc Motor Drive Circuit
Manufacturer
NXP Semiconductors
Datasheet
1.TDA5144T.pdf
(20 pages)
Philips Semiconductors
Other design aspects
There are other design aspects concerning the application
of the TDA5144 besides the commutation function. They
are:
FG
The FG signal is generated in the TDA5144 by using the
zero-crossing of the motor EMF from the three motor
windings. Every zero-crossing in a (star connected) motor
winding is used to toggle the FG output signal. The FG
frequency is therefore half the commutation frequency. All
transitions indicate the detection of a zero-crossing.
The accuracy of the FG output signal depends on the
symmetry of the motor's electromagnetic construction,
which also effects the satisfactory functioning of the motor
itself.
Example: a 3-phase motor with 6 magnetic pole-pairs at
1500 rpm and with a full-wave drive has a commutation
frequency of 25
signal of 450 Hz.
June 1994
Generation of the tacho signal FG
General purpose operational transconductance
amplifier (OTA)
Possibilities of motor control
Reliability.
Brushless DC motor drive circuit
If the chosen value of CAP-TI is too small oscillations can occur in certain positions of a blocked rotor. If the chosen value is too large, then it
is possible that the motor may run in the reverse direction (synchronously with little torque).
SIGNAL
6
Fig.10 Typical CAP-TI and V
6 = 900 Hz, and generates a tacho
MOT1
voltage waveforms in normal running mode.
14
T
The OTA is an uncommitted amplifier with a high output
current (40 mA) that can be used as a control amplifier.
The common mode input range includes ground (GND)
and rises to V
OTA to drive a power transistor directly in an analog
control amplifier.
Although the gain is not extremely high (0.3 S), care must
be taken with the stability of the circuit if the OTA is used
as a linear amplifier as no frequency compensation has
been provided.
The convention for the inputs (inverting or not) is the same
as for a normal operational amplifier: with a resistor (as
load) connected from the output (AMP OUT) to the positive
supply, a positive-going voltage is found when the
non-inverting input (+AMP IN) is positive with respect to
the inverting input ( AMP IN). Confusion is possible
because a ‘plus’ input causes less current, and so a
positive voltage.
HE
O
PERATIONAL
P
1.7 V. The high sink current enables the
T
RANSCONDUCTANCE
Product specification
A
TDA5144
MPLIFIER
(OTA)