isd-t360sb ETC-unknow, isd-t360sb Datasheet - Page 56

• Manufacturer Part Number: isd-t360sb
• Manufacturer: ETC-unknow

ISD-T360SB
Graphical User Interface (GUI)
The IVS package includes a Windows utility to assist the vocabulary designer to synthesize sentences. With
this utility, you can record words, compose sentences and listen to words and sentences in the specific
compression rate quality selected.
HOW TO USE THE IVS TOOL WITH THE
VOICEDSP PROCESSOR
The IVS tool creates IVS vocabularies, and stores them as a binary file. This file is burnt into a ROM device
or programmed into a Flash memory device using the INJ (Inject IVS) command. The VoiceDSP processor
SO (Say One Word) command is used to select the required vocabulary. The SW (Say Words), SO, SS (Say
Sentence) and SAS (Say Argumented Sentence) commands are used to synthesize the required word or
sentence. The typical vocabulary-creation process using the IVS Tool software is as follows:
Once the vocabulary is in place, the speech synthesis commands of the VoiceDSP processor can be
used to synthesize sentences.
Figure 2-5 shows the vocabulary-creation process for a single table on a ROM or Flash memory device.
2-20
1. Design the vocabulary.
2. Create the vocabulary files (as described in detail below). Use IVS TOOL for Windows to simplify this
3. Record the words using any standard PC sound card and sound editing software, that can cre-
4. Run the IVS compiler to compress the.wav files, and compile them and the vocabulary tables into
5. Repeat steps 1 to 4 to create a separate IVS vocabulary for each language that you want to use.
6. Exit IVS Tool and burn the IVS vocabulary files into a ROM (or Flash memory) device. Use the INJ
7. For injecting vocabularies with multiple languages into the flash memory:
process.
ate.wav files.
an IVS vocabulary file.
Note that each language file must have a different ID number. To specify an ID Number, go to
the “Vocabulary ID” option in the Vocabulary/Build Options menu.
(Inject IVS) command to program the data into a Flash device.
• From a DOS prompt, issue the following DOS command: copy voc1.bin + voc2.bin
• The two files are now combined into a single file.
• Inject the united vocabulary file using the INJ command. (See page 2-40 for details.)
• To switch between the two languages in real time operation, use the SV command. (See page
voc_both.bin (where voc1.bin and voc2.bin are the two vocabulary files and voc_both.bin is
the combined file.)
2-52 for details.) The SV type id command switches between specified vocabulary IDs.
Voice Solutions in Silicon™
2—SOFTWARE