isd-t360sb ETC-unknow, isd-t360sb Datasheet - Page 75

• Manufacturer Part Number: isd-t360sb
• Manufacturer: ETC-unknow

2—SOFTWARE
Example
GTUNE
Gets the value of the tunable parameter identified by index (one byte) as the 2-byte value,
parameter_value . This command may be used to read and identify the parameter value that was set to
tune the VoiceDSP.
If index does not point to a valid tunable parameter, ERR_PARAM is set in the error word.
This index parameter should be in a hexidecimal value.
The GTUNE command may be used in IDLE state or RESET state. If TUNE command was not used to set
the tunable parameters, then the GTUNE command will read the default parameter value.
Example
Table 2-4 through Table 2-12 describe the tunable parameters, their index numbers in decimal, and their
default values.
ISD
GTM FFCE 003F 00
Byte sequence:
Description:
GTUNE 17
Byte sequence:
Description:
Microcontroller
VoiceDSP
Select the oldest of the new ICMs, in mailbox number 6, to be the current message, for a system
where the message tag is encoded as described in the example for the DMS command.
The VoiceDSP processor returns a value indicates that there is such a message.
The following pseudo-code demonstrates how to play all new ICMs in mailbox number 6. The
messages are marked as old after being played:
Microcontroller
VoiceDSP
Get the minimum period for busy detection
ComactSPEECH responds:
Get Tune index
Return_val = GTM(FFCE, 003F, 00) /*Get the oldest message with the defined tag*/
While (Return_Val == TRUE)
Begin
P() /* Play */
Message_tag = GMT() /* Get message tag */
SMT(FFF7) /* Mark the message as ‘old’ */
GTM(FFCE, 003F, 01) /* Get next message with the same tag */
End
700 (7 seconds).
09
09
FF
FF
CE
CE
06
06
00
00
17
17
3F
3F
AA
02
00
00
ISD-T360SB
BC
AA
AA
01
2-39