hd64338342hw Renesas Electronics Corporation., hd64338342hw Datasheet - Page 213

• Manufacturer Part Number: hd64338342hw
• Description: Renesas 8-bit Single-chip Microcomputer H8 Family/h8/300l Super Low Power Series
• Manufacturer: Renesas Electronics Corporation.

6.7
There are two modes for programming/erasing of the flash memory; boot mode, which enables on-
board programming/erasing, and programmer mode, in which programming/erasing is performed
with a PROM programmer. On-board programming/erasing can also be performed in user
program mode. At reset-start in reset mode, the device changes to a mode depending on the TEST
pin settings, P24 pin settings, and input level of each port, as shown in table 6.8. The input level of
each pin must be defined four states before the reset ends.
When changing to boot mode, the boot program built into this LSI is initiated. The boot program
transfers the programming control program from the externally-connected host to on-chip RAM
via SCI32. After erasing the entire flash memory, the programming control program is executed.
This can be used for programming initial values in the on-board state or for a forcible return when
programming/erasing can no longer be done in user program mode. In user program mode,
individual blocks can be erased and programmed by branching to the user program/erase control
program prepared by the user.
Table 6.8
TEST
0
0
1
X: Don’t care
On-Board Programming Modes
P24
1
0
X
Setting Programming Modes
P26
X
1
X
PB0
X
X
0
PB1
X
X
0
PB2
X
X
0
Rev. 6.00 Aug 04, 2006 page 177 of 680
LSI State after Reset End
User Mode
Boot Mode
Programmer Mode
REJ09B0145-0600
Section 6 ROM