m95256 STMicroelectronics, m95256 Datasheet - Page 19
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
m95256
Manufacturer Part Number
m95256
Description
256 Kbit Serial Spi Bus Eeprom With High Speed Clock
Manufacturer
STMicroelectronics
Datasheet
1.M95256.pdf
(43 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
m95256-DFMC6TG
Manufacturer:
STMicroelectronics
Quantity:
950
Part Number:
m95256-DFMC6TG
Manufacturer:
ST
Quantity:
20 000
Part Number:
m95256-DRDW3TP/K
Manufacturer:
ST
Quantity:
20 000
Part Number:
m95256-DRMN3TP/K
Manufacturer:
ST
Quantity:
20 000
M95256, M95256-W, M95256-R
Table 5.
1. As defined by the values in the Block Protect (BP1, BP0) bits of the Status Register, as shown in
The protection features of the device are summarized in
When the Status Register Write Disable (SRWD) bit of the Status Register is 0 (its initial
delivery state), it is possible to write to the Status Register provided that the Write Enable
Latch (WEL) bit has previously been set by a Write Enable (WREN) instruction, regardless
of the whether Write Protect (W) is driven high or low.
When the Status Register Write Disable (SRWD) bit of the Status Register is set to 1, two
cases need to be considered, depending on the state of Write Protect (W):
Regardless of the order of the two events, the Hardware Protected Mode (HPM) can be
entered:
The only way to exit the Hardware Protected Mode (HPM) once entered is to pull Write
Protect (W) high.
If Write Protect (W) is permanently tied high, the Hardware Protected Mode (HPM) can
never be activated, and only the Software Protected Mode (SPM), using the Block Protect
(BP1, BP0) bits of the Status Register, can be used.
W signal
1
0
1
0
If Write Protect (W) is driven high, it is possible to write to the Status Register provided
that the Write Enable Latch (WEL) bit has previously been set by a Write Enable
(WREN) instruction.
If Write Protect (W) is driven low, it is not possible to write to the Status Register even if
the Write Enable Latch (WEL) bit has previously been set by a Write Enable (WREN)
instruction. (Attempts to write to the Status Register are rejected, and are not accepted
for execution). As a consequence, all the data bytes in the memory area that are
software protected (SPM) by the Block Protect (BP1, BP0) bits of the Status Register,
are also hardware protected against data modification.
by setting the Status Register Write Disable (SRWD) bit after driving Write Protect (W)
low
or by driving Write Protect (W) low after setting the Status Register Write Disable
(SRWD) bit.
SRWD
Protection modes
bit
0
0
1
1
Protected
Hardware
Protected
Software
(HPM)
(SPM)
Mode
Write protection of the
Status Register is
Writable (if the WREN
instruction has set the
WEL bit)
The values in the BP1
and BP0 bits can be
changed
Status Register is
Hardware write
protected
The values in the BP1
and BP0 bits cannot be
changed
Status Register
Write-protected
Write-protected
Protected area
Table
2.
Memory content
(1)
Ready to accept Write
instructions
Ready to accept Write
instructions
Unprotected area
Instructions
Table
5.
19/43
(1)