s-24cs16a Seiko Instruments Inc., s-24cs16a Datasheet - Page 20

• Manufacturer Part Number: s-24cs16a
• Description: 2-wire Cmos Serial E2prom
• Manufacturer: Seiko Instruments Inc.

20
2-WIRE CMOS SERIAL E
S-24CS16A
1. Adding a pull-up resistor to SDA I/O pin and SCL input pin
2. I/O pin equivalent circuit
Using S-24CS16A
Add a 1 to 5 k Ω pull-up resistor to the SCL input pin
bus protocol. Normal communication cannot be provided without a pull-up resistor.
*1. When the SCL input pin of the E
The I/O pins of this IC do not include pull-up and pull-down resistors. The SDA pin is an open-drain output. The following
shows the equivalent circuits.
same pull-up resistor to prevent a high impedance status from being input to the SCL input pin.
This protects the E
when the microprocessor is reset when the voltage drops.
SCL
SDA
WP
2
PROM from malfunction due to an undefined output (high impedance) from the tri-state pin
2
PROM
2
PROM is connected to a tri-state output pin of the microprocessor, connect the
Seiko Instruments Inc.
Figure 23 SCL Pin
Figure 24 SDA Pin
Figure 25 WP Pin
*1
and the SDA I/O pin in order to enable the functions of the I
Rev.5.1
2
C -
00