atmega161-4pi ATMEL Corporation, atmega161-4pi Datasheet - Page 35

• Manufacturer Part Number: atmega161-4pi
• Description: 8-bit Microcontroller With 16k Bytes Of In-system Programmable Flash
• Manufacturer: ATMEL Corporation

1228D–AVR–02/07
grammer’s purpose, it is recommended to set the Sleep Enable (SE) bit just before the
execution of the SLEEP instruction.
• Bit 4
The SM1 bit, together with the SM0 control bit in EMCUCR, selects between the three
available Sleep modes as shown in Table 6.
Table 6. Sleep Mode Select
• Bits 3, 2
The External Interrupt 1 is activated by the external pin INT1 if the SREG I-Flag and the
corresponding interrupt mask in the GIMSK are set. The level and edges on the external
INT1 pin that activate the interrupt are defined in Table 7. The value on the INT1 pin is
sampled before detecting edges. If edge or toggle interrupt is selected, pulses that last
longer than one clock period will generate an interrupt. Shorter pulses are not guaran-
teed to generate an interrupt. If low-level interrupt is selected, the low level must be held
until the completion of the currently executing instruction to generate an interrupt.
Table 7. Interrupt 1 Sense Control
• Bits 1, 0
The External Interrupt 0 is activated by the external pin INT0 if the SREG I-Flag and the
corresponding interrupt mask is set. The level and edges on the external INT0 pin that
activate the interrupt are defined in Table 8. The value on the INT0 pin is sampled
before detecting edges. If edge or toggle interrupt is selected, pulses that last longer
than one clock period will generate an interrupt. Shorter pulses are not guaranteed to
generate an interrupt. If low-level interrupt is selected, the low level must be held until
the completion of the currently executing instruction to generate an interrupt.
Table 8. Interrupt 0 Sense Control
ISC11
ISC01
0
0
1
1
0
0
1
1
–
SM1
SM1: Sleep Mode Select Bit 1
0
0
1
1
–
–
ISC10
ISC00
ISC11, ISC10: Interrupt Sense Control 1 Bit 1 and Bit 0
ISC01, ISC00: Interrupt Sense Control 0 Bit 1 and Bit 0
0
1
0
1
0
1
0
1
Description
The low level of INT1 generates an interrupt request.
Any logical change on INT1 generates an interrupt request.
The falling edge of INT1 generates an interrupt request.
The rising edge of INT1 generates an interrupt request.
Description
The low level of INT0 generates an interrupt request.
Any logical change on INT0 generates an interrupt request.
The falling edge of INT0 generates an interrupt request.
The rising edge of INT0 generates an interrupt request.
SM0
0
1
0
1
Sleep Mode
Idle
Reserved
Power-down
Power-save
ATmega161(L)
35