p89lpc932ba NXP Semiconductors, p89lpc932ba Datasheet - Page 38

• Manufacturer Part Number: p89lpc932ba
• Description: P89lpc932 8-bit Microcontroller With Accelerated Two-clock 80c51 Core 8 Kb Flash With 512-byte Data Eeprom And 768-byte Ram
• Manufacturer: NXP Semiconductors

Philips Semiconductors
9397 750 12379
Product data
Fig 19. Comparator input and output connections.
(P0.5) CMPREF
(P0.4) CIN1A
(P0.3) CIN1B
(P0.2) CIN2A
(P0.1) CIN2B
V REF
8.22.1 Internal reference voltage
8.22 Analog comparators
Two analog comparators are provided on the P89LPC932. Input and output options
allow use of the comparators in a number of different configurations. Comparator
operation is such that the output is a logical one (which may be read in a register
and/or routed to a pin) when the positive input (one of two selectable pins) is greater
than the negative input (selectable from a pin or an internal reference voltage).
Otherwise the output is a zero. Each comparator may be configured to cause an
interrupt when the output value changes.
The overall connections to both comparators are shown in
comparators function to V
When each comparator is first enabled, the comparator output and interrupt flag are
not guaranteed to be stable for 10 microseconds. The corresponding comparator
interrupt should not be enabled during that time, and the comparator interrupt flag
must be cleared before the interrupt is enabled in order to prevent an immediate
interrupt service.
When a comparator is disabled the comparator’s output, COx, goes HIGH. If the
comparator output was LOW and then is disabled, the resulting transition of the
comparator output from a LOW to HIGH state will set the comparator flag, CMFx.
This will cause an interrupt if the comparator interrupt is enabled. The user should
therefore disable the comparator interrupt prior to disabling the comparator.
Additionally, the user should clear the comparator flag, CMFx, after disabling the
comparator.
An internal reference voltage generator may supply a default reference when a single
comparator input pin is used. The value of the internal reference voltage, referred to
as V
REF
, is 1.23 V 10%.
CN1
CN2
CP1
CP2
Comparator 1
Comparator 2
Rev. 04 — 06 January 2004
8-bit microcontroller with accelerated two-clock 80C51 core
DD
CO1
CO2
= 2.4 V.
Change Detect
Change Detect
OE1
OE2
CMF1
CMF2
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
CMP1 (P0.6)
CMP2 (P0.0)
Figure
P89LPC932
EC
002aaa422
19. The
Interrupt
38 of 60