p89lpc917 NXP Semiconductors, p89lpc917 Datasheet - Page 36
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
p89lpc917
Manufacturer Part Number
p89lpc917
Description
8-bit Microcontrollers With Accelerated Two-clock 80c51 Core 2 Kb 3 V Flash With 8-bit A/d Converter
Manufacturer
NXP Semiconductors
Datasheet
1.P89LPC917.pdf
(72 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
p89lpc9171FDH
Manufacturer:
NXP
Quantity:
7 460
Part Number:
p89lpc9171FDH
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
p89lpc917FDH
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Philips Semiconductors
9397 750 14397
Product data
9.11.1 External interrupt inputs
The P89LPC916supports 14 interrupt sources: external interrupt 0, timers 0 and 1,
serial port Tx, serial port Rx, combined serial port Rx and Tx, brownout detect,
Watchdog/Real-Time clock, I2C, keyboard, comparators 1 and 2, SPI, and the A/D
converter.
Each interrupt source can be individually enabled or disabled by setting or clearing a
bit in the interrupt enable registers IEN0 or IEN1. The IEN0 register also contains a
global disable bit, EA, which disables all interrupts.
Each interrupt source can be individually programmed to one of four priority levels by
setting or clearing bits in the interrupt priority registers IP0, IP0H, IP1, and IP1H. An
interrupt service routine in progress can be interrupted by a higher priority interrupt,
but not by another interrupt of the same or lower priority. The highest priority interrupt
service cannot be interrupted by any other interrupt source. If two requests of
different priority levels are pending at the start of an instruction, the request of higher
priority level is serviced.
If requests of the same priority level are pending at the start of an instruction, an
internal polling sequence determines which request is serviced. This is called the
arbitration ranking. Note that the arbitration ranking is only used to resolve pending
requests of the same priority level.
The P89LPC915 and P89LPC917 have two external interrupt inputs as well as the
Keypad Interrupt function. The P89LPC916 has one external interrupt input as well as
the Keypad Interrupt function These external interrupt inputs are identical to those
present on the standard 80C51 microcontrollers.
These external interrupts can be programmed to be level-triggered or edge-triggered
by setting or clearing bit IT1 or IT0 in Register TCON.
In edge-triggered mode, if successive samples of the INTn pin show a HIGH in one
cycle and a LOW in the next cycle, the interrupt request flag IEn in TCON is set,
causing an interrupt request.
If an external interrupt is enabled when the P89LPC915/916/917 is put into
Power-down or Idle mode, the interrupt will cause the processor to wake-up and
resume operation. Refer to
Rev. 04 — 17 December 2004
8-bit microcontrollers with accelerated two-clock 80C51 core
Section 9.14 “Power reduction modes”
P89LPC915/916/917
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
for details.
36 of 72