ak4561 AKM Semiconductor, Inc., ak4561 Datasheet - Page 38

• Manufacturer Part Number: ak4561
• Description: 16bit Codec With Built-in Alc And Mic/hp-amp
• Manufacturer: AKM Semiconductor, Inc.

ASAHI KASEI
n ALC Operation
1. ALC Limiter Operation
During the ALC limiter operation, when either Lch or Rch exceed ALC limiter detection level (LMTH), IPGA value is
attenuated by ALC limiter ATT step (LMAT1-0) automatically. Then the IPGA value is changed commonly for L/R
channels.
In case of ZELM = “0”, timeout period is set by LTM1-0 bits. The operation for attenuation is done continuously until the
input signal level becomes LMTH or less. After finishing the operation for attenuation, if ALC bit does not change into
“0”, the operation of attenuation repeats when the input signal level exceed LMTH. (Refer to Figure 26)
In case of ZELM = “1”, timeout period is set by ZTM1-0 bits. The IPGA value is attenuated by zero crossing detection
automatically. (Refer to Figure 27)
When FR bit is “0”, the ALC operation corresponds to the impulse noise in additional to the ALC operation of AK4516A.
When the impulse noise is input, the ALC recovery operation becomes the faster period than a normal recovery operation.
When FR bit is “1”, the ALC operation in AK4561 is the same as AK4516A’s.
(1). When the signal is input between 2dB, the AK4561 does not operate the ALC limiter and recovery.
Rev. 0.9
[Explanation for ALC operation]
Limiter detection level(LMTH)
Recovery waiting counter
)
reset level (LMTH)
ATT level (LMAT1-0)
Figure 26. Disable ALC zero crossing detection (ZELM = “0”)
(1) 2dB
Limiter starts
AKM CONFIDENTIAL
Limiter update period (LTM1-0)
- 38 -
ATT level (LMAT1-0)
ATT level (LMAT1-0)
Limiter finish
[AK4561]
2000/09