ak4561 AKM Semiconductor, Inc., ak4561 Datasheet - Page 40

• Manufacturer Part Number: ak4561
• Description: 16bit Codec With Built-in Alc And Mic/hp-amp
• Manufacturer: AKM Semiconductor, Inc.

ASAHI KASEI
2. ALC Recovery Operation
The ALC recovery operation waits until a time of setting WTM1-0 bits after completing the ALC limiter. If the input
signal does not exceed “Recovery waiting counter reset level ”, the ALC recovery operation is done. The IPGA value
increases automatically by this operation up to the set reference level (REF6-0 bits). Then the IPGA value is set for L/R
commonly. The ALC recovery operation is done at a period set by WTM1-0 bits.
When L/R channels are detected by zero crossing operation during WTM1-0, the ALC recovery operation waits until
WTM1-0 period and the next recovery operation is done.
During the ALC recovery operation, when either input signal level of Lch or Rch exceeds the ALC limiter detection level
(LMTH), the ALC recovery operation changes into the ALC limiter operation immediately
In case of “(Recovery waiting counter reset level)
operation, the waiting timer of ALC recovery operation is reset. Therefore, in case of “(Recovery waiting counter reset
level) > Input Signal”, the waiting timer of ALC recovery operation starts.
(1). When the input signal is below the ALC recovery waiting counter reset level, the ALC recovery operation waits the
(2). The IPGA value is changed by the zero crossing operation in ALC recovery operation, but the next counter of the
Other:
When a channel of one side enters the limiter operation during the waiting zero crossing, the present ALC recovery
operation stops, according as the small value of IPGA (a channel of waiting zero crossing), the ALC limiter operation is
done.
When both channels are waiting for the next ALC recovery operation, the ALC limiter operation is done from the IPGA
value of a point in time.
During the ALC operation, the value of writing in IPGA6-0 bits is ignored.
Rev. 0.9
WTM counter starts
time set by WTM1-0 bits. If the input signal does not exceed the ALC limiter detection level or the ALC recovery
waiting counter reset level, the ALC recovery operation is done only once.
ALC recovery waiting timer is also starting.
(2)
Figure 28. The transition from the limiter operation to the recovery operation
During recovery counter reset
WTM counter starts
AKM CONFIDENTIAL
Input Signal < (Limiter detection level)” during the ALC recovery
- 40 -
ZTM counter starts
WTM counter starts
(1)
ZTM counter starts
WTM counter starts
(2)
Limiter detection level (LMTH)
Recovery waiting counter
reset level (LMTH)
Zero crossing detect
(2)
[AK4561]
2000/09