PCF85321 NXP [NXP Semiconductors], PCF85321 Datasheet - Page 14

• Manufacturer Part Number: PCF85321
• Description: Universal LCD driver for low multiplex rates
• Manufacturer: NXP [NXP Semiconductors]

NXP Semiconductors
PCF8532_1
Product data sheet
7.10 Display RAM
7.9 Backplane outputs
The LCD drive section includes four backplane outputs: BP0 to BP3. The backplane
output signals are generated in accordance with the selected LCD drive mode.
If less than four backplane outputs are required the unused outputs can be left
open-circuit.
The pins for the four backplanes BP0 to BP3 are available on both pin bars of the chip. In
applications it is possible to use either the pins for the backplanes
When using all backplanes available they may be connected to the respective sibling (BP0
on the top pin bar with BP0 on the bottom pin bar and so on).
The display RAM is a static 160
bit map indicates the on-state of the corresponding LCD element (it is shaded); similarly, a
logic 0 indicates the off-state (it is translucent). There is a one-to-one correspondence
between the RAM addresses and the segment outputs and between the individual bits of
a RAM word and the backplane outputs. The first RAM row corresponds to the
160 elements operated with respect to backplane BP0 (see
applications the segment data of the first, second, third and fourth row of the display RAM
are time-multiplexed with BP0, BP1, BP2 and BP3 respectively.
When display data is transmitted to the PCF8532 the display bytes received are stored in
the display RAM in accordance with the selected LCD drive mode. The data is stored as it
arrives and does not wait for the acknowledge cycle as with the commands. Depending on
the current multiplex mode data is stored singularly, in pairs, triplets or quadruplets, e.g. in
1:2 multiplex mode the RAM data is stored every second bit. To illustrate the filling order,
an example of a 7-segment numeric display showing all drive modes is given in
the RAM filling organization depicted applies equally to other LCD types.
The following applies to
•
•
•
•
•
•
•
•
•
In the 1:4 multiplex drive mode BP0 to BP3 must be connected directly to the LCD.
In 1:3 multiplex drive mode BP3 carries the same signal as BP1, therefore these two
adjacent outputs can be tied together to give enhanced drive capabilities.
In 1:2 multiplex drive mode BP0 and BP2, BP1 and BP3 respectively carry the same
signals and may also be paired to increase the drive capabilities.
In static drive mode the same signal is carried by all four backplane outputs and they
can be connected in parallel for very high drive requirements.
on the top pin bar
on the bottom pin bar
or both of them to increase the driving strength of the device.
In static drive mode the eight transmitted data bits are placed in row 0 to eight
successive display RAM addresses.
In 1:2 multiplex mode the eight transmitted data bits are placed in row 0 and 1 to four
successive display RAM addresses.
Rev. 1 — 10 February 2009
Figure
10:
4-bit RAM which stores LCD data. A logic 1 in the RAM
Universal LCD driver for low multiplex rates
Figure
9). In multiplexed LCD
PCF8532
© NXP B.V. 2009. All rights reserved.
Figure
14 of 44
10;