AT89C51CC03U-S3SIM ATMEL [ATMEL Corporation], AT89C51CC03U-S3SIM Datasheet - Page 150

• Manufacturer Part Number: AT89C51CC03U-S3SIM
• Description: Enhanced 8-bit MCU with CAN Controller and Flash Memory
• Manufacturer: ATMEL [ATMEL Corporation]

150
AT89C51CC03
Table 99. CCAPMn Registers
CCAPM0 (S:DAh)
CCAPM1 (S:DBh)
CCAPM2 (S:DCh)
CCAPM3 (S:DDh)
CCAPM4 (S:DEh)
PCA Compare/Capture Module n Mode registers (n=0..4)
Reset Value = X000 0000b
Number
Bit
7
-
7
6
5
4
3
2
1
0
Mnemonic Description
ECOMn
ECOMn
CAPPn
CAPNn
ECCFn
PWMn
TOGn
MATn
Bit
6
-
Reserved
The Value read from this bit is indeterminate. Do not set this bit.
Enable Compare Mode Module x bit
Clear to disable the Compare function.
Set to enable the Compare function.
The Compare function is used to implement the software Timer, the high-speed
output, the Pulse Width Modulator (PWM) and the WatchDog Timer (WDT).
Capture Mode (Positive) Module x bit
Clear to disable the Capture function triggered by a positive edge on CEXx pin.
Set to enable the Capture function triggered by a positive edge on CEXx pin
Capture Mode (Negative) Module x bit
Clear to disable the Capture function triggered by a negative edge on CEXx pin.
Set to enable the Capture function triggered by a negative edge on CEXx pin.
Match Module x bit
Set when a match of the PCA Counter with the Compare/Capture register sets
CCFx bit in CCON register, flagging an interrupt.
Toggle Module x bit
The toggle mode is configured by setting ECOMx, MATx and TOGx bits.
Set when a match of the PCA Counter with the Compare/Capture register
toggles the CEXx pin.
Pulse Width Modulation Module x Mode bit
Set to configure the module x as an 8-bit Pulse Width Modulator with output
waveform on CEXx pin.
Enable CCFx Interrupt bit
Clear to disable CCFx bit in CCON register to generate an interrupt request.
Set to enable CCFx bit in CCON register to generate an interrupt request.
CAPPn
5
CAPNn
4
MATn
3
TOGn
2
4182I–CAN–06/05
PWMn
1
ECCFn
0