PX1011A-ELG NXP [NXP Semiconductors], PX1011A-ELG Datasheet - Page 18
![no-image](/images/no-image-200.jpg)
PX1011A-ELG
Manufacturer Part Number
PX1011A-ELG
Description
PCI Express stand-alone X1 PHY
Manufacturer
NXP [NXP Semiconductors]
Datasheet
1.PX1011A-ELG.pdf
(32 pages)
Philips Semiconductors
PX1011A_PX1012A_2
Product data sheet
8.12 Setting negative disparity
8.13 JTAG boundary scan interface
To set the running disparity to negative, the MAC asserts TXCOMP for one clock cycle
that matches with the data that is to be transmitted with negative disparity.
Joint Test Action Group (JTAG) or IEEE 1149.1 is a standard, specifying how to control
and monitor the pins of compliant devices on a printed-circuit board. This standard is
commonly known as ‘JTAG Boundary Scan’.
This standard defines a 5-pin serial protocol for accessing and controlling the signal levels
on the pins of a digital circuit, and has some extensions for testing the internal circuitry on
the chip itself, which is beyond the scope of this data sheet.
Access to the JTAG interface is provided to the customer for the sole purpose of using
boundary scan for interconnect test verification between other compliant devices that may
reside on the board. Using JTAG for purposes other than boundary scan may produce
undesired effects.
The JTAG interface is a 3.3 V CMOS signaling. JTAG TRST_N must be asserted LOW for
normal device operation. If JTAG is not planned to be used, it is recommended to
pull down TRST_N to V
Fig 16. Setting negative disparity
TXDATA[7:0]
TX_P, TX_N
TXCOMP
TXCLK
data
valid data
SS
Rev. 02 — 18 May 2006
.
K28.5
K28.5
PX1011A/PX1012A
PCI Express stand-alone X1 PHY
K28.5
K28.5
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
byte transmitted
with negative disparity
K28.5
K28.5
002aac177
18 of 32