STM8L151G4Y3 STMICROELECTRONICS [STMicroelectronics], STM8L151G4Y3 Datasheet - Page 62

• Manufacturer Part Number: STM8L151G4Y3
• Description: 8-bit ultralow power MCU, up to 32 KB Flash, 1 KB Data EEPROM RTC, LCD, timers, USART, I2C, SPI, ADC, DAC, comparators
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

Electrical parameters
62/122
Table 15.
1. Positive injection is not possible on these I/Os. V
2. I
3. When several inputs are submitted to a current injection, the maximum ΣI
Table 16.
Symbol
never be exceeded. A negative injection is induced by V
cannot be respected, the injection current must be limited externally to the I
injection is induced by V
positive and negative injected currents (instantaneous values). These results are based on
characterization with ΣI
INJ(PIN)
T
ΣI
Symbol
I
STG
INJ(PIN)
T
INJ(PIN)
I
I
J
VDD
VSS
I
IO
must never be exceeded. This is implicitly insured if V
Current characteristics
Thermal characteristics
Storage temperature range
Maximum junction temperature
Total current into V
Total current out of V
Output current sunk by IR_TIM pin (with high sink LED
driver capability)
Output current sunk by any other I/O and control pin
Output current sourced by any I/Os and control pin
Injected current on true open-drain pins (PC0 and PC1)
Injected current on FT pins (PA7 and PE0)
Injected current on any other pin
Total injected current (sum of all I/O and control pins)
INJ(PIN)
IN
>V
DD
maximum current injection on four I/O port pins of the device.
while a negative injection is induced by V
Doc ID 15962 Rev 5
Ratings
DD
SS
power line (source)
ground line (sink)
Ratings
IN
maximum must always be respected. I
(2)
IN
<V
SS
IN
.
maximum is respected. If V
(1)
INJ(PIN)
IN
STM8L151xx, STM8L152xx
<V
INJ(PIN)
(3)
SS
-65 to +150
(1)
is the absolute sum of the
.
value. A positive
Min
150
INJ(PIN)
Max.
± 25
- 25
± 5
- 5
- 5
80
80
80
25
IN
maximum
must
Unit
Unit
° C
mA