ATMEGA644PV ATMEL [ATMEL Corporation], ATMEGA644PV Datasheet - Page 132

• Manufacturer Part Number: ATMEGA644PV
• Description: 8-bit Microcontroller with 16/32/64K Bytes In-System Programmable Flash
• Manufacturer: ATMEL [ATMEL Corporation]

132
ATmega164P/324P/644P
Table 14-3 on page 132
the fast PWM mode.
Table 14-3.
Note:
Table 14-4 on page 132
the phase correct or the phase and frequency correct, PWM mode.
Table 14-4.
Note:
• Bit 1:0 – WGMn1:0: Waveform Generation Mode
Combined with the WGMn3:2 bits found in the TCCRnB Register, these bits control the counting
sequence of the counter, the source for maximum (TOP) counter value, and what type of wave-
form generation to be used, see
Timer/Counter unit are: Normal mode (counter), Clear Timer on Compare match (CTC) mode,
and three types of Pulse Width Modulation (PWM) modes.
COMnA1/COMnB1
COMnA1/COMnB1
1. A special case occurs when OCRnA/OCRnB equals TOP and COMnA1/COMnB1 is set. In
1. A special case occurs when OCRnA/OCRnB equals TOP and COMnA1/COMnB1 is set.
0
0
1
1
0
0
1
1
this case the compare match is ignored, but the set or clear is done at BOTTOM.
“14.9.3” on page 123.
Section “14.9.4” on page 125.
Compare Output Mode, Fast PWM
Compare Output Mode, Phase Correct and Phase and Frequency Correct
PWM
(1)
shows the COMnx1:0 bit functionality when the WGMn3:0 bits are set to
shows the COMnx1:0 bit functionality when the WGMn3:0 bits are set to
COMnA0/COMnB0
COMnA0/COMnB0
for more details.
0
1
0
1
0
1
0
1
Table 14-5 on page
for more details.
Description
Normal port operation, OCnA/OCnB disconnected.
WGMn3:0 = 14 or 15: Toggle OC1A on Compare
Match, OC1B disconnected (normal port operation).
For all other WGM1 settings, normal port operation,
OC1A/OC1B disconnected.
Clear OCnA/OCnB on Compare Match, set
OCnA/OCnB at BOTTOM (non-inverting mode)
Set OCnA/OCnB on Compare Match, clear
OCnA/OCnB at BOTTOM (inverting mode)
Description
Normal port operation, OCnA/OCnB disconnected.
WGMn3:0 = 9 or 11: Toggle OCnA on Compare
Match, OCnB disconnected (normal port operation).
For all other WGM1 settings, normal port operation,
OC1A/OC1B disconnected.
Clear OCnA/OCnB on Compare Match when up-
counting. Set OCnA/OCnB on Compare Match when
downcounting.
Set OCnA/OCnB on Compare Match when up-
counting. Clear OCnA/OCnB on Compare Match
when downcounting.
(1)
133. Modes of operation supported by the
(See Section “14.9” on page
8011D–AVR–02/07
See Section
122.).
See