MC9S12E32CFU FREESCALE [Freescale Semiconductor, Inc], MC9S12E32CFU Datasheet - Page 113

• Manufacturer Part Number: MC9S12E32CFU
• Description: HCS12 Microcontrollers
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

2.4.1.3.4
The mass erase operation will erase all addresses in a Flash array using an embedded algorithm.
An example flow to execute the mass erase operation is shown in
write sequence is as follows:
If a Flash array to be erased contains any protected area, the PVIOL flag in the FSTAT register will set and
the mass erase command will not launch. Once the mass erase command has successfully launched, the
CCIF flag in the FSTAT register will set after the mass erase operation has completed unless a new
command write sequence has been buffered.
Freescale Semiconductor
1. Write to a Flash array address to start the command write sequence for the mass erase command.
2. Write the mass erase command, 0x41, to the FCMD register.
3. Clear the CBEIF flag in the FSTAT register by writing a 1 to CBEIF to launch the mass erase
The address and data written will be ignored.
command.
Mass Erase Command
MC9S12E128 Data Sheet, Rev. 1.07
Figure
Chapter 2 128 Kbyte Flash Module (FTS128K1V1)
2-25. The mass erase command
113