ST62P08C ST Microelectronics, ST62P08C Datasheet - Page 63
![no-image](/images/no-image-200.jpg)
ST62P08C
Manufacturer Part Number
ST62P08C
Description
(ST62P08C - ST62P20C) 8-BIT MCU
Manufacturer
ST Microelectronics
Datasheet
1.ST62P08C.pdf
(105 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
11.2 ABSOLUTE MAXIMUM RATINGS
Stresses above those listed as “absolute maxi-
mum ratings” may cause permanent damage to
the device. This is a stress rating only and func-
tional operation of the device under these condi-
11.2.1 Voltage Characteristics
11.2.2 Current Characteristics
11.2.3 Thermal Characteristics
Notes:
1. Directly connecting the RESET and I/O pins to V
2. When the current limitation is not possible, the V
3. Power (V
4. Negative injection disturbs the analog performance of the device. In particular, it induces leakage currents throughout
is generated or an unexpected change of the I/O configuration occurs (for example, due to a corrupted program coun-
ter). To guarantee safe operation, this connection has to be done through a pull-up or pull-down resistor (typical: 4.7k
for RESET, 10k
figuration.
I
the device including the analog inputs. To avoid undesirable effects on the analog functions, care must be taken:
- Analog input pins must have a negative injection less than 1mA (assuming that the impedance of the analog voltage
is lower than the specified limits).
- Pure digital pins must have a negative injection less than 1mA. In addition, it is recommended to inject the current as
far as possible from the analog input pins.
INJ(PIN)
I
INJ(PIN)
V
V
Symbol
Symbol
Symbol
ESD(HBM)
DD
T
I
I
specification. A positive injection is induced by V
V
VDD
VSS
I
STG
T
DD
IO
- V
IN
J
2) & 4)
) and ground (V
SS
for I/Os). Unused I/O pins must be tied in the same way to V
Supply voltage
Input voltage on any pin
Electro-static discharge voltage (Human Body Model)
Total current into V
Total current out of V
Output current sunk by any standard I/O and control pin
Output current sunk by any high sink I/O pin
Output current source by any I/Os and control pin
Injected current on RESET pin
Injected current on any other pin
Storage temperature range
Maximum junction temperature
(see THERMAL CHARACTERISTICS section)
SS
) lines must always be connected to the external supply.
DD
SS
power lines (source)
Ratings
Ratings
Ratings
ground lines (sink)
1) & 2)
DD
IN
or V
absolute maximum rating must be respected, otherwise refer to
SS
IN
>V
could damage the device if an unintentional internal reset
tions is not implied. Exposure to maximum rating
conditions for extended periods may affect device
reliability.
DD
while a negative injection is induced by V
ST6208C/ST6209C/ST6210C/ST6220C
3)
3)
DD
or V
V
Maximum value
Maximum value
SS
SS
-0.3 to V
-60 to +150
according to their reset con-
Value
3500
100
80
20
40
15
7
5
5
DD
+0.3
IN
<V
Unit
Unit
Unit
mA
V
63/105
SS
C
.
1