ZL50408GDC ZARLINK [Zarlink Semiconductor Inc], ZL50408GDC Datasheet - Page 70

• Manufacturer Part Number: ZL50408GDC
• Description: Managed 8-Port 10/100M 1-Port 10/100/1000M Ethernet Switch
• Manufacturer: ZARLINK [Zarlink Semiconductor Inc]

Port 8: (CPU Port)
Port 9: (GMAC Port)
Bit [1:0]:
Bit [2]:
Bit [4:3]:
Bit [5]:
Bit [6]:
Bit [7]:
Bit [0]:
Bit [1]:
0: Disable (Default)
1: Enable
Should be enabled only in serial mode and disabled in 8/16-bit mode.
Enable insertion of 2-byte CPU information in CPU frame packet in Serial + MII
mode
00: No information is inserted (Default)
01: Insert 2-byte of CPU information
10: Reserved
11: Insert 6-byte of padding + 2-byte of CPU information
In port-based VLAN mode, the CPU MII interface must be in “No information is
inserted” mode (ECR4P8[4:3]='00'). In tagged-based VLAN mode, the CPU MII
interface supports all three modes (0,2,8 bytes insertion).
Frame loopback.
0: Disable frame from sending back to its source port. (Default)
1: Allow frame to send back to its source port
In a regular ethernet switch, a packet should never be receive and forwarded to
the same port. Setting the bit allows it to happen.
This is not the same as an ingress MAC loopback. The destination MAC address
has to be stored (learned) in the MCT and associated with the originating source
port. The frame loopback will only work for unicast packets.
0: Normal operation (Default)
1: Reset. Not self clearing.
Enable RXCLK output. Active high
0: Disable (Default)
1: M9_RXCLK pin becomes output in MII mode
Note: To configure port 9 with the device providing the interface clocks, you need
to tie M9_RXCLK to M9_MTXCLK externally as M9_MTXCLK is not a bidirectional
clock.
Reserved
Enable special write to 2 registers in a single write operation.
Reserved
Soft reset.
Reserved
Zarlink Semiconductor Inc.
ZL50408
70
Data Sheet