LC89052TA-E SANYO [Sanyo Semicon Device], LC89052TA-E Datasheet - Page 9

• Manufacturer Part Number: LC89052TA-E
• Description: Digital Audio Interface Receiver
• Manufacturer: SANYO [Sanyo Semicon Device]

8. Function Description
8.1 System Reset (
• The system operates normally when
• When power is on, resetting must be done with the
• If a crystal oscillator is used, you must wait to start normal operation for at least 10ms until the oscillation gets stable
8.2 Low-Power Modes
• The LC89052TA-E supports two low-power modes: the mode in which whole circuit is controlled with the
• The low-power mode controlled by the
• The pins that are available with the low-power settings except for the oscillation amplifier are only the XIN pin and
• The pins that are available with the PDOWN[1:0] low-power mode settings except those for the oscillator amplifier
• When the oscillator amplifier is stopped by the AMPOPR in a low-power mode setup with PDOWN[1:0] or when this
• When the low-power mode is set with PDOWN[1:0], it is possible to write to the microcontroller registers. However,
you set the
after the
and the mode in which only special functions are controlled by the PDOWN[1:0].
and the registers are initialized.
XOUT pin. These can be used to provide the master clock for the DSP and other circuits.
and its divider circuit are only the CKOUT, BCK, LRCK, DATAO, SDIN, XIN and XOUT pins. This mode can be
used to minimize power consumption during analog data processing.
circuit is already stopped, it is impossible for the LC89052TA-E to provide a clock output. Thus the AMPOPR takes
precedence. Note that the PLLOPR setting is invalid and the PLL circuit is stopped.
all the sub-code Q and channel status that are read are fixed at a low level.
_____
PD pin goes from low to high.
PD pin to low again after power is applied, the system is reset.
_____
V DD
PD
_____
PD)
PD pin is set to high level after a supply voltage is rises to 2.7V or higher. When
_____
Figure 8.1
_____
PD applies to the entire circuit of the LC89052TA-E. All clocks are stopped
System reset
2.7V
PD Pin Levels at Power On
_____
LC89052TA-E
_____
PD pin set to low.
t
2.0V
System operation
t > 200µ
No.7457-9/42
PD pin
_____