UBA2024AT PHILIPS [NXP Semiconductors], UBA2024AT Datasheet - Page 4

• Manufacturer Part Number: UBA2024AT
• Description: Half-bridge power IC for CFL lamps
• Manufacturer: PHILIPS [NXP Semiconductors]

NXP Semiconductors
7. Functional description
UBA2024
Product data sheet
7.1 Supply voltage
7.2 Start-up state
7.3 Sweep mode
7.4 Reset
7.5 Oscillation
The UBA2024 does not require an external low-voltage supply as the mains supply
voltage applied to pin HV powers it. The IC derives its own low supply voltage from this for
its internal circuitry.
With an increase of the supply voltage on pin HV, the IC enters the start-up state. In the
start-up state the high-side power transistor is not conducting and the low-side power
transistor is switched on. The internal circuit is reset and the capacitors on the bootstrap
pin FS and low-voltage supply pin V
ground. The start-up state is defined until V
The IC enters the sweep mode when the voltage on pin V
on pin SW is charged by I
the start-up state again when the voltage on pin V
The sweep time (t
capacitor (C
During the sweep time the current flowing through the lamp electrodes performs some
preheating of the filaments. See
A DC reset circuit is incorporated in the high-side driver. The high-side transistor is
switched off when the voltage on pin FS is below the high-side lockout voltage V
The oscillation is based upon the 555-timer function. A self oscillating circuit is made with
the external resistor R
To realize an accurate 50 % duty cycle, an internal divider is used. This reduces the bridge
frequency to half the oscillator frequency.
The output voltage of the bridge will change at the falling edge of the signal on pin RC.
The design equation for the half-bridge frequency is:
An overview of the oscillator signal, internal LS and HS drive signals and the output is
given in
t
sweep
f
osc
=
Figure
=
---------------------------------------- -
k
C
×
SW
SW
R
OSC
). Typical the total sweep time set by C
4.
(
All information provided in this document is subject to legal disclaimers.
nF
1
sweep
×
)
C
×
Rev. 6.2 — 1 November 2010
OSC
OSC
10.3 ms
) is determined by the charge current (I
SW
and the capacitor C
and the half-bridge circuit starts oscillating. The circuit enters
Figure
DD
are charged. Pins RC and SW are switched to
5.
DD
OSC
= V
DD(startup)
DD
(see
Half-bridge power IC for CFL lamps
< V
SW
Figure
DD(stop)
is:
DD
.
> V
ch(sw)
4).
.
DD(startup)
) and the external
UBA2024
© NXP B.V. 2010. All rights reserved.
. The capacitor
float(UVLO)
4 of 17
(1)
(2)
.