WIZ105SR-EVB WIZnet, WIZ105SR-EVB Datasheet - Page 15

• Manufacturer Part Number: WIZ105SR-EVB
• Description: Interface Development Tools EVALUATION BOARD FOR WIZ105SR
• Manufacturer: WIZnet
• Type: Serial to Ethernetr

Specifications of WIZ105SR-EVB

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: WIZ105SR
• Interface Type: Ethernet, RS-232
• Operating Supply Voltage: 3.3 V
• Dimensions: 40 mm x 62 mm x 17 mm
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Operating Supply Current: 250 mA

Gateway box will be enabled. Input Static IP address and click “setting” button. Then set the
IP address as you wanted. (PPPoE ID, Password box is disabled)
- DHCP: Set this option to use DHCP mode. Firstly, check ‘DHCP’ and click ‘Setting’ button. If
IP address is successfully acquired from DHCP server, the MAC address will be displayed on the
configuration window. (It takes some time to acquire IP address from DHCP server)
When a module on the board list is selected, IP address, Subnet mask and Gateway are
displayed. If module could not acquire network information from DHCP server, IP address,
Gateway Address and Subnet mask will be initialized to 0.0.0.0.
- PPPoE : WIZ105SR supports PPPoE for ADSL user. When you select PPPoE at the “IP
Configuration Method”, PPPoE ID & Password box is enabled.
1. To set PPPoE, connect PC to WIZ105SR directly and execute Configuration Tool program on
PC. (Configuration Tool Version should be 2.1 or above)
2. Select ‘PPPoE’ of the “IP Configuration Method” tab and input ID & Password.
3. Click “setting” button to apply.
4. Connect Module to ADSL Line.
5. If “Enable Serial Debug Mode” is selected, you can see PPPoE access status via serial
console.
ⓔ Local IP/Port : WIZ105SR’s IP address and Port number for network connection
☞
cause network collision or mal-function.
Hardwired Internet Connectivity Wizard (WIZnet, Inc.)
Be sure to input correct network information. If you input incorrect IP address, it can
WIZ105SR Ver. 03.06
-- PHASE 0. PPPoE(ADSL) setup process --
-- PHASE 1. PPPoE Discovery process -- ok
-- PHASE 2. LCP process -- ok
-- PHASE 3. PPPoE(ADSL) Authentication mode --
Authentication protocol : c223 00,
-- Waiting for PPPoE server's admission --ok
-- PHASE 4. IPCP process --ok
Figure 3. PPPoE Access Process
15