MD4331-D1G-V3Q18-X/Y SanDisk, MD4331-D1G-V3Q18-X/Y Datasheet - Page 21

no-image

MD4331-D1G-V3Q18-X/Y

Manufacturer Part Number
MD4331-D1G-V3Q18-X/Y
Description
IC MDOC G3 1GB 69-FBGA
Manufacturer
SanDisk
Datasheet

Specifications of MD4331-D1G-V3Q18-X/Y

Format - Memory
FLASH
Memory Type
FLASH - Nand
Memory Size
1G (128M x 8)
Speed
55ns
Interface
Parallel
Voltage - Supply
2.5 V ~ 3.6 V
Operating Temperature
-40°C ~ 85°C
Package / Case
*
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Other names
585-1134

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MD4331-D1G-V3Q18-X/Y
Manufacturer:
SanDisk
Quantity:
10 000
18
The following abbreviations are used: IN - Standard (non-Schmidt) input, ST - Schmidt Trigger input, OD - Open drain output, R8 - Nominal
22K pull-up resistor, enabled only for 8-bit interface mode (IF_CFG input is 0)
IRQ#
DPD
VCC
VCCQ
VSS
RSRVD
Signal
See Figure 4
Ball No.
G3, J9
G2
F9
E4
J5
J6
M
A
Input
Type
OD
ST
-
-
-
-
-
-
Preliminary Data Sheet, Rev. 1.1
Device supply. Requires a 10 nF and 0.1 μF
I/O power supply. Sets the logic ‘1’ voltage level
Interrupt Request, active low. A 10 KΩ pull-up
resistor is required if this ball drives an input. A 10
KΩ pull-up resistor is recommended even if this
ball is not used.
Deep Power-Down. Used to enter and exit Deep
Power-Down mode. Pin is assigned A0 instead of
DPD when working in 8-bit mode.
capacitor.
range of I/O balls. VCCQ may be either 2.5V to
3.6V or 1.65V to 2.0V. Requires a 10 nF and
0.1 μF capacitor.
Ground. All VSS balls must be connected.
Reserved. If compatibility with previous
DiskOnChip versions is necessary:
In 16-bit mode (IF_CFG = 1) this ball must be
connected to GND for compatibility with G2
devices.
In 8-bit mode (IF_CFG = 0) may be left floating.
Refer to application note AP-DOC-067 for design
guidelines when migrating from previous
DiskOnChip versions (G2).
Reserved. Other reserved signals are not
connected internally and must be left floating to
guarantee forward compatibility with future
products.
Mechanical. These balls are for mechanical
placement, and are not connected internally.
Alignment. This ball is for device alignment and is
not connected internally.
Power
Other
Description
Mobile DiskOnChip G3
91-SR-011-05-8L
Supply
Supply
Supply
Signal
Output
Type
Input

Related parts for MD4331-D1G-V3Q18-X/Y