MD2533-D8G-X-P/Y SanDisk, MD2533-D8G-X-P/Y Datasheet - Page 64
![no-image](/images/manufacturer_photos/0/5/581/sandisk_sml.jpg)
MD2533-D8G-X-P/Y
Manufacturer Part Number
MD2533-D8G-X-P/Y
Description
IC MDOC H3 8GB FBGA
Manufacturer
SanDisk
Type
Flash Disk Moduler
Specifications of MD2533-D8G-X-P/Y
Format - Memory
FLASH
Memory Type
FLASH - Nand
Memory Size
8G (1G x 8)
Interface
Parallel
Voltage - Supply
1.65 V ~ 1.95 V, 2.5 V ~ 3.6 V
Operating Temperature
-40°C ~ 85°C
Package / Case
115-LFBGA
Density
1GByte
Operating Supply Voltage (typ)
1.8/3.3V
Operating Temperature (min)
-40C
Operating Temperature (max)
85C
Package Type
FBGA
Mounting
Surface Mount
Pin Count
115
Operating Temperature Classification
Industrial
Operating Supply Voltage (min)
1.65/2.7V
Operating Supply Voltage (max)
1.95/3.6V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Speed
-
Lead Free Status / Rohs Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Note: mDOC H3 does NOT use this signal to indicate that the flash is in busy state (e.g. program,
9.10.4 Working with 16/32-Bit Systems
mDOC H3 uses a 16-bit data bus and supports 16-bit data access by default. However, it can be
configured to support 32-bit data access mode. This section describes the connections required
for each mode.
The default of the DOC driver for mDOC H3 is set to work in 16-bit mode. It must be specially
configured to support 32-bit mode. Please see DOC Driver or TrueFFS 7.1 documentation for
further details.
Note: The mDOC H3 data bus must be connected to the Least Significant Bits (LSB) of the
16-Bit (Word) Data Access Mode
The mDOC H3 is 16 bit wide device. All accesses to and from the device are 16 bit wide.
mDOC H3 address lines should be connected to system host address lines, as depicted in Figure
14.
mDOC H3 A0 line should be connected either to system host SA0 address line, or to VSS.
32-Bit (Double Word) Data Access Mode
In a 32-bit bus system that cannot execute word-aligned accesses, the system address lines SA0
and SA1 are always 0. Consecutive double words (32-bit words) are differentiated by SA2
toggling. Therefore, in 32-bit systems that support only 32-bit data access cycles, mDOC H3
signal A1 is connected to the first system address bit that toggles; i.e., SA2.
mDOC H3 address lines should be connected to system host address lines, as depicted in Figure
16.
mDOC H3 A0 line should be connected either to system host SA1 address line, or to VSS
64
read, or erase).
system.
Note:
The prefix “SA” indicates system host address lines
Figure 15: 16-Bit Data Access Mode
Data Sheet (Preliminary) Rev. 0.2
mDOC H3 Embedded Flash Drive
92-DS-1205-10