TDF5140AP/C1,112 NXP Semiconductors, TDF5140AP/C1,112 Datasheet - Page 16
![IC MOTOR DVR BRUSHLESS 18-PDIP](/photos/7/45/74588/18-dip__300mil__sml.jpg)
TDF5140AP/C1,112
Manufacturer Part Number
TDF5140AP/C1,112
Description
IC MOTOR DVR BRUSHLESS 18-PDIP
Manufacturer
NXP Semiconductors
Type
Brushless DC Motor Controllerr
Datasheet
1.TDF5140APC1112.pdf
(19 pages)
Specifications of TDF5140AP/C1,112
Package / Case
18-DIP (0.300", 7.62mm)
Mounting Type
Through Hole
Current - Output
800mA
Voltage - Supply
4 V ~ 18 V
Operating Temperature
-30°C ~ 70°C
Applications
DC Motor Driver, Brushless (BLDC), 3 Phase
Number Of Outputs
1
Supply Current
5 mA
Mounting Style
Through Hole
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Voltage - Load
-
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
935265573112
Philips Semiconductors
T
The OTA is an uncommitted amplifier with a high output
current (40 mA) that can be used as a control amplifier.
The common mode input range includes ground (GND)
and rises to V
OTA to drive a power transistor directly in an analog
control amplifier.
Although the gain is not extremely high (0.3 S), care must
be taken with the stability of the circuit if the OTA is used
as a linear amplifier as no frequency compensation has
been provided.
The convention for the inputs (inverting or not) is the same
as for a normal operational amplifier: with a resistor (as
load) connected from the output (AMP OUT) to the positive
supply, a positive-going voltage is found when the
non-inverting input (+AMP IN) is positive with respect to
the inverting input ( AMP IN). Confusion is possible
because a 'plus' input causes less current, and so a
positive voltage.
M
DC motors can be controlled in an analog manner using
the OTA.
For the control an external transistor is required. The OTA
can supply the base current for this transistor and act as a
control amplifier.
1999 March 15
HE
OTOR
Brushless DC motor drive circuit
O
PERATIONAL
C
ONTROL
P
1.7 V. The high sink current enables the
T
RANSCONDUCTANCE
A
MPLIFIER
(OTA)
16
R
It is necessary to protect high current circuits and the
output stages are protected in two ways:
It is possible, that when braking, the motor voltage (via the
flyback diodes and the impedance on VMOT) may cause
higher currents than allowed ( 0.6 A). These currents
must be limited externally.
ELIABILITY
Current limiting of the 'lower' output transistors. The
'upper' output transistors use the same base current as
the conducting 'lower' transistor (+15%). This means
that the current to and from the output stages is limited.
Thermal protection of the six output transistors is
achieved by each transistor having a thermal sensor
that is active when the transistor is switched on. The
transistors are switched off when the local temperature
becomes too high.
Product specification
TDF5140A