L6910 STMicroelectronics, L6910 Datasheet - Page 7

• Manufacturer Part Number: L6910
• Description: IC PWM BUCK BST VM 16SOIC
• Manufacturer: STMicroelectronics

Specifications of L6910

• Pwm Type: Voltage Mode
• Number Of Outputs: 1
• Frequency - Max: 230kHz
• Duty Cycle: 100%
• Voltage - Supply: 5 V ~ 12 V
• Buck: Yes
• Boost: Yes
• Flyback: No
• Inverting: No
• Doubler: No
• Divider: No
• Cuk: No
• Isolated: No
• Operating Temperature: -40°C ~ 150°C
• Package / Case: 16-SOIC (3.9mm Width)
• Frequency-max: 230kHz
• Output Voltage: 4 V
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-3656-5; 497-4220-5; 497-4220-5

L6910 - L6910A
avoided if the PHASE pin is over about 500mV. The lower mos is in any case turned-on after 200ns from the
high side turn-off.
The peak current is shown for both the upper (fig. 6) and the lower (fig. 7) driver at 5V and 12V. A 3.3nF capac-
itive load has been used in these measurements.
For the lower driver, the source peak current is 1.1A @ V
= 12V and 500mA @ V
= 5V, and the sink peak
CC
CC
current is 1.3A @ V
= 12V and 500mA @ V
= 5V.
CC
CC
Similarly, for the upper driver, the source peak current is 1.3A @ Vboot-Vphase = 12V and 600mA @ Vboot-
Vphase = 5V, and the sink peak current is 1.3A @ Vboot-Vphase =12V and 550mA @ Vboot-Vphase = 5V.
Figure 6. High Side Driver Peak Current. Vboot-Vphase = 12V (right) Vboot-Vphase = 5V (left)
CH1 = High Side Gate CH4 = Gate Current
Figure 7. Low Side Driver Peak Current. V
= 12V (right) V
= 5V (left)
CC
CC
CH1 = Low Side Gate CH4 = Gate Current
4.5 Monitoring and Protections
The output voltage is monitored by means of pin FB. If it is not within ±10% (typ.) of the programmed value, the
powergood output is forced low.
The device provides overvoltage protection, when the voltage sensed on pin FB reaches a value 17% (typ.)
greater than the reference the OSC pin is forced high (3V typ.) and the lower driver is turned on as long as the
over-voltage is detected.
7/29