LTM4612MPV#PBF Linear Technology, LTM4612MPV#PBF Datasheet - Page 8

• Manufacturer Part Number: LTM4612MPV#PBF
• Description: IC BUCK SYNC ADJ 5A 133LGA
• Manufacturer: Linear Technology
• Series: µModuler
• Type: Point of Load (POL) Non-Isolatedr

Specifications of LTM4612MPV#PBF

• Design Resources: LTM4612 Spice Model
• Output: 3.3 ~ 15 V
• Number Of Outputs: 1
• Power (watts): 75W
• Mounting Type: Surface Mount
• Voltage - Input: 5 ~ 36 V
• Package / Case: 133-LGA
• 1st Output: 3.3 ~ 15 VDC @ 5A
• Size / Dimension: 0.59" L x 0.59" W x 0.11" H (15mm x 15mm x 2.8mm)
• Power (watts) - Rated: 75W
• Operating Temperature: -55°C ~ 125°C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -

LTM4612
pin FuncTions
V
Internally, this pin is connected to V
sion resistor. Different output voltages can be programmed
with an additional resistor between the V
See the Applications Information section.
MARG0 (Pin C12): LSB Logic Input for the Margining
Function. Together with the MARG1 pin, the MARG0 pin
will determine if a margin high, margin low, or no margin
state is applied. The pin has an internal pull-down resistor
of 50k. See the Applications Information section.
MARG1 (Pins C11, D12): MSB Logic Input for the Margin-
ing Function. Together with the MARG0 pin, the MARG1 pin
will determine if a margin high, margin low, or no margin
state is applied. The pins have an internal pull-down resistor
of 50k. See the Applications Information section.
SGND (Pins D9, H12): Signal Ground Pins. These pins
connect to PGND at output capacitor point.

FB
(Pin F12): The Negative Input of the Error Amplifier.
OUT
FB
with a 100k preci-
and SGND pins.
COMP (Pins A11, D11): Current Control Threshold and
Error Amplifier Compensation Point. The current com-
parator threshold increases with this control voltage. The
voltage ranges from 0V to 2.4V with 0.7V corresponding
to zero sense voltage (zero current).
PGOOD (Pin G12): Output Voltage Power Good Indicator.
Open-drain logic output that is pulled to ground when the
output voltage is not within ±10% of the regulation point,
after a 25µs power bad mask timer expires.
RUN (Pins A10, B9): Run Control Pins. A voltage above
1.9V will turn on the module, and below 1V will turn off
the module. A programmable UVLO function can be ac-
complished with a resistor from V
a 5.1V zener to ground. Maximum pin voltage is 5V.
NC (Pins J12, K12, L12): No Connect Pins.
IN
to this pin that is has
4612fa