DLP-2232M-G DLP Design Inc, DLP-2232M-G Datasheet - Page 9

• Manufacturer Part Number: DLP-2232M-G
• Description: MODULE USB ADAPTER FOR FT2232D
• Manufacturer: DLP Design Inc

Specifications of DLP-2232M-G

• Main Purpose: Interface, USB 2.0 to UART (RS232) Bridge
• Embedded: No
• Utilized Ic / Part: FT2232D
• Primary Attributes: Full Speed USB to High-Speed UART
• Secondary Attributes: Royalty-Free Drivers, 2K EEPROM
• Interface Type: USB
• Data Bus Width: 8 bit
• Operating Supply Voltage: 4.35 V to 5.25 V
• Product: Interface Modules
• For Use With/related Products: FT2232D
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 813-1000

4.0 Module Pin-Out
4.1 Pin Definitions
This section describes the operation of the DLP-2232M-G pins. Common pins are
defined in the first section and the I/O pins are defined by chip mode. More detailed
descriptions of the operation of the I/O pins are provided in section x. (was 9)
4.2 Common Pins
The operation of the following DLP-2232M-G pins stay the same, regardless of the
operating mode.
Pin# Signal
27
26
19
Rev 1.6 (May 2009)
RSTIN#
RSTOUT#
EXTVCC
Figure 2. Pin-Out (40 Pin DIP Header )
Type
Input
Output Output of the internal Reset Generator. Stays high
PWR
Description
Can be used by an external device to reset the FT2232D. If
not required, can be left disconnected.
impedance for ~5ms after VCC > 3.5V and the
internal clock starts up, then clamps it’s output to the 3.3V
output of the internal regulator.
Taking RESET# low will also force RSTOUT# to drive
low. RSTOUT# is NOT affected by a USB Bus Reset.
+4.35 to +5.25 volt VCC to the device core, LDO and non-
20
1
Header
40 Pin,
.6 inch
Connector
USB 'B'
6.000
Type
9
40
21
DLP-2232M-G DLP Design, Inc.