101-1218 Rabbit Semiconductor, 101-1218 Datasheet - Page 16

• Manufacturer Part Number: 101-1218
• Description: KIT APPLCTN RABBITCORE RCM4010
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore®r

Specifications of 101-1218

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: RCM4010
• Primary Attributes: *
• Secondary Attributes: *
• Processor To Be Evaluated: Rabbit 4000
• Interface Type: Ethernet
• Operating Supply Voltage: 12 V
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1156

2.2.3 Step 3 — Connect Programming Cable
The programming cable connects the module to the PC running Dynamic C to download
programs and to monitor the module during debugging.
Connect the 10-pin connector of the programming cable labeled
the RCM4000/RCM4010/RCM4050 as shown in Figure 4. Be sure to orient the marked
(usually red) edge of the cable towards pin 1 of the connector. (Do not use the
nector, which is used for a normal serial connection.)
Depending on the programming cable, connect the other end to a COM port or a USB port
on your PC.
10
NOTE: Never disconnect the programming cable by pulling on the ribbon cable.
NOTE: Either a serial or a USB programming cable was supplied with this Development
Carefully pull on the connector to remove it from the header.
Kit. If you have a serial programming cable, an RS-232/USB converter (Rabbit Part
No. 20-151-0178) is available to allow you to use the serial programming cable with a
USB port.
Figure 4. Connect Programming Cable and Power Supply
PROG
RabbitCore RCM4000
to header J1 on
DIAG
con-