101-1218 Rabbit Semiconductor, 101-1218 Datasheet - Page 86

• Manufacturer Part Number: 101-1218
• Description: KIT APPLCTN RABBITCORE RCM4010
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore®r

Specifications of 101-1218

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: RCM4010
• Primary Attributes: *
• Secondary Attributes: *
• Processor To Be Evaluated: Rabbit 4000
• Interface Type: Ethernet
• Operating Supply Voltage: 12 V
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1156

6.5 Run the PINGME.C Sample Program
Connect the crossover cable from your computer’s Ethernet port to the RCM4000 mod-
ule’s RJ-45 Ethernet connector. Open this sample program from the
ICMP
cable is connected from your computer’s Ethernet adapter to the RCM4000 module’s
RJ-45 Ethernet connector. When the program starts running, the green
RCM4000 module should be on to indicate an Ethernet connection is made. (Note: If the
LNK
with straight-through cables perhaps the power is off on the hub.)
The next step is to ping the module from your PC. This can be done by bringing up the
MS-DOS window and running the pingme program:
or by
and typing the entry
Notice that the yellow
place, and indicates the transfer of data. The ping routine will ping the module four times
and write a summary message on the screen describing the operation.
6.6 Running Additional Sample Programs With Direct Connect
The following sample programs are in the Dynamic C
folder.
•
•
•
80
BROWSELED.C
Two “device LEDs” are created along with two buttons to toggle them. Users can use
their Web browser to change the status of the lights. The DS2 and DS3 LEDs on the
Prototyping Board will match those on the Web page. As long as you have not modified
the
your Web browser to bring up the Web page served by the sample program.
Otherwise use the TCP/IP settings you entered in the
PINGLED.C
LEDs DS2 and DS3 on the Prototyping Board when a ping is sent and received.
SMTP.C
the S2 and S3 switches on the Prototyping Board are pressed. LEDs DS2 and DS3 on
the Prototyping Board will light up when e-mail is being sent.
http://10.10.6.100.
light does not light, you may not be using a crossover cable, or if you are using a hub
Start > Run
folder, compile the program, and start it running under Dynamic C. The crossover
ping 10.10.6.101
ping 10.10.6.101
TCPCONFIG 1
—This program demonstrates using the SMTP library to send an e-mail when
—This program demonstrates ICMP by pinging a remote host. It will flash
—This program demonstrates a basic controller running a Web page.
macro in the sample program, enter the following server address in
ACT
light flashes on the RCM4000 module while the ping is taking
SAMPLES\RCM4000\TCPIP\
TCP_CONFIG.LIB
SAMPLES\TCPIP\
LINK
RabbitCore RCM4000
library.
light on the