Z8FMC160100KITG Zilog, Z8FMC160100KITG Datasheet - Page 14

• Manufacturer Part Number: Z8FMC160100KITG
• Description: KIT DEV FOR Z8 ENCORE Z8FMC16100
• Manufacturer: Zilog
• Series: Z8 Encore! MC™r

Specifications of Z8FMC160100KITG

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: Z8FMC16100
• Primary Attributes: 3-Ph DC Motors
• Secondary Attributes: Graphical User Interface
• For Use With: 269-4664 - KIT ACC OPTO-ISO USB SMART CABLE269-4661 - KIT ACC ETHERNET SMART CABLE269-4539 - KIT ACCESSORY USB SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4660

Troubleshooting Tips
If you experience trouble running the sample code with the Z8FMC16100 Series Motor
Control Development kit, determine if any of the following items can resolve the issue
before contacting
•
•
•
•
•
•
•
•
•
If you perform these steps and cannot get the sample code to run, contact Zilog Technical
Support at www.zilog.com.
QS005406-0111
Verify that you are using ZDS II version 5.0.0 or later.
Ensure that you are using the unmodified sample project code as described in
ing Sample Code in Debug Mode using ZDS II
Verify that you have properly connected the USB Opto-Isolator Smart Cable to the
host PC and the MC MDS board as described in
Driver Software and USB Smart Cable
properly aligned with DBG connector pin 1 of the MC MDS board.
After you have connected the 5 V DC power supply to the MC MDS board, the green
3.3 V DC LED D4 must be illuminated. If it is not illuminated, verify that power is
properly connected to the board as described in
Power Supply to the MC MDS Board
In ZDS II, navigate to
verify that the serial number for the USB Opto-Isolator Smart Cable interface is pres-
ent and selected. If the serial number is missing, reinstall the USB Opto-Isolator Smart
Cable driver software.
In ZDS II, verify that
In ZDS II, click the
errors.
Verify that the development board is not currently running any code
should not be spinning.
Try reloading the sample project as described in
Mode using ZDS II
Zilog Technical Support
Rebuild All
on page 6.
Z8FMC16100KITG - USB
Project
Z8FMC16100 Series Motor Control Development Kit
←
Settings
button. Verify that the project rebuilds with no
on page 5.
for assistance.
on page 7. Ensure that pin 1 of the cable is
←
Debugger
on page 6.
Step 4. Connect the 5 V DC Universal
is selected as the target.
Executing Sample Code in Debug
Step 3. Install the USB Smart Cable
←
Communication
Quick Start Guide
–
the motor
Page 14 of 15
Execut-
and