IS-DEV KIT-7 NKK Switches, IS-DEV KIT-7 Datasheet - Page 19

• Manufacturer Part Number: IS-DEV KIT-7
• Description: KIT DEV FOR OLED SWITCH
• Manufacturer: NKK Switches
• Series: SmartSwitch™r

Specifications of IS-DEV KIT-7

• Main Purpose: Switches with Programmable Display
• Embedded: Yes, ASIC
• Utilized Ic / Part: ISC15ANP4
• Primary Attributes: 2 OLED Switches, PC Board with Flash Memory
• Secondary Attributes: Power and Programming Connections
• Description/function: SMARTSWITCH Development Kit
• For Use With: 360-2431 - SERIAL CBL RJ11-DB9 FOR DEV KIT360-2430 - POWER SUPPLY 240VAC FOR DEV KIT360-2429 - POWER SUPPLY 120VAC FOR DEV KIT
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Smart Switch - OLED
• Other names: 360-2339

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
6. Hardware
Controls Overview
The Mode Select Switch has two settings; “Switch” is for the OLED (64x48) switches and “Display” is for the
OLED (52x36) displays.
The Connector is for the installation of the Logic Boards onto the controller. One pin is keyed to reduce miss
mates.
The Batt/PWR switch has three positions: battery, off, line power.
Buzzer Volume adjusts the volume of the buzzer that activates when a button is pushed.
The 9V DC Power jack mates with a 2.5mm cylinder power connector. Center positive.
The RS232 Connector links the controller to the host.
Note: To turn off the controller, press both switches at the same time until the switches are off then
turn off the Batt/PWR switch. This step must be followed to comply with OLED power off
requirement.
CL01 Intelligent Controller Users Manual B.doc
Note: Improper installation of the Logic Boards could damage either/both the Logic Board and
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
RS232
CL01 Intelligent Controller Users Manual
www.nkkswitches.com • Email [e-mail]
1
2
GND
controller.
3
TX
4
RX
5
GND
6
Page 19 of 24
0110