M3A-0033 Renesas Electronics America, M3A-0033 Datasheet - Page 33

• Manufacturer Part Number: M3A-0033
• Description: DEV EVALUATION BOARD FOR M66291G
• Manufacturer: Renesas Electronics America

Specifications of M3A-0033

• Main Purpose: USB Controller
• Embedded: *
• Utilized Ic / Part: M66291
• Primary Attributes: *
• Secondary Attributes: *
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

9.10 Corrective Action when Error Occurs During Download
9.11 Corrective Action when Error Occurs "A source file isn't found"
9.12 Notes about Power Supply
9.13 Reset Signal
M66291GP Evaluation Board
When a wrong occurs during download or reload (Ex. stop download), may be a problem that a part of program will
be running. When run download or reload , will have to push a reset button on KD308 before running download or
reload. After, will be download or reload.
Confirm the following contents when the error of "A source file isn't found." occurs.
-
-
Please supply power and set jumpers correctly, and be careful especially of the polarity of power supply.
M3A-0033 has no prevention function for power supply reverse putting. M3A-0033 becomes unusable if done.
- In the case of connecting M3A-0032, please set JP1 of M3A-0032 to "EXIOVCC" side.
- In the case of connecting M3A-0029B, please set JP6 of M3A-0033 to "3.3V" side.
Note: If the above-mentioned jumper setup is not done when using M3A-0032 and M3A-0029B,
When JP11 is short-circuited, you can program the hardware-reset of the M66291 low pulsing P7
Please refer the M66291 data sheet for the timing.
Note: When you program doesn’t hardware-reset the M66291, please open JP11.
Does it exist in the directory (or, folder) that an executive file is the same as the source file.
Isn't a source file being opened with edit except for KD308?
M3A-0033 and M3A-0032 and M3A-0029B may become impossible to use, please be careful of use.
If JP11 is short-circuited and P7
0
isn’t cared, reset pin of the M66291 may be unstable.
- 29 -
0
M3A-0033
of the M16C/80.