STEVAL-ISA051V1 STMicroelectronics, STEVAL-ISA051V1 Datasheet - Page 23
![BOARD EVAL PM6670S DDR2/3](/photos/9/13/91334/steval-isa051v1_sml.jpg)
STEVAL-ISA051V1
Manufacturer Part Number
STEVAL-ISA051V1
Description
BOARD EVAL PM6670S DDR2/3
Manufacturer
STMicroelectronics
Type
DC/DC Switching Converters, Regulators & Controllersr
Specifications of STEVAL-ISA051V1
Design Resources
STEVAL-ISA051V1 Gerber Files STEVAL-ISA051V1 Schematic STEVAL-ISA051V1 Bill of Material
Main Purpose
Special Purpose DC/DC, DDR Memory Supply
Outputs And Type
4, Non-Isolated
Voltage - Output
1.5V, 1.8V
Voltage - Input
4.5 ~ 28V
Regulator Topology
Buck
Board Type
Fully Populated
Utilized Ic / Part
PM6670
Input Voltage
4.5 V to 28 V
Output Voltage
1.8 V, 1.5 V
Product
Power Management Modules
Silicon Manufacturer
ST Micro
Silicon Core Number
PM6670S
Kit Application Type
Power Management
Application Sub Type
DDR2/3 Memory Power Supply Controller
Kit Contents
Board
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Current - Output
-
Power - Output
-
Frequency - Switching
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With/related Products
PM6670S
Other names
497-8411
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
STEVAL-ISA051V1
Manufacturer:
STMicroelectronics
Quantity:
1
PM6670S
7.1.1
Figure 30. Switching section simplified block diagram
Constant-on-time architecture
Figure 30
The switching regulator of the PM6670S owns a one-shot generator that ignites the high-
side MOSFET when the following conditions are simultaneously satisfied: the PWM
comparator is high (i.e. output voltage is lower than Vr = 0.9 V), the synchronous rectifier
current is below the current limit threshold and the minimum off-time has expired.
A minimum off-time constraint (300 ns typ.) is introduced to assure the boot capacitor
charge and allow inductor valley current sensing on low-side MOSFET. A minimum on-time
is also introduced to assure the start-up switching sequence.
Once the on-time has timed out, the high side switch is turned off, while the synchronous
rectifier is ignited according to the anti-cross conduction management circuitry.
When the output voltage reaches the valley limit (determined by internal reference
Vr = 0.9 V), the low-side MOSFET is turned off according to the anti-cross conduction logic
once again, and a new cycle begins.
shows the simplified block diagram of the constant-on-time controller.
Doc ID 14432 Rev 4
Device description
23/54