DK86060-3 Fujitsu Semiconductor America Inc, DK86060-3 Datasheet - Page 13

• Manufacturer Part Number: DK86060-3
• Description: KIT DEV 16BIT DAC FOR MB86060
• Manufacturer: Fujitsu Semiconductor America Inc

Specifications of DK86060-3

• Number Of Dac's: 1
• Number Of Bits: 16
• Outputs And Type: 1, Differential
• Sampling Rate (per Second): 400M
• Data Interface: Parallel
• Dac Type: Current
• Voltage Supply Source: Single
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: MB86060
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 865-1009

February 2009 Version 2.0
FME/MS/SFDAC1/DS/4250
MB86060 16-bit Interpolating Digital to Analog Converter
1.8.2
Power savings can be made by reducing the full scale analog output current (I
However, to maintain the specified performance, I
should be pre-scaled to achieve full scale deflection at an output current lower than full scale (I
1.8.3
The analog outputs, IOUT and IOUTB, are each connected to two pins to reduce output inductance.
These pins should be directly connected together on the PCB.
Analog Out
1.9
16-bit data is input through pins D[15:0]. D15 is the MSB. Data may be presented in either Unsigned
Binary or 2’s Complement format, depending upon the setting of the TWOC pin. See Table 9.
The Digital Data interface has CMOS inputs. The voltage levels of the input data must not exceed
the specifications in section 5.2. Data from a 5V source must not be presented directly to the Digital
Data Interface.
Copyright © 2003-2009 Fujitsu Microelectronics Europe GmbH
Disclaimer: The contents of this document are subject to change without notice. Customers are advised to consult with FUJITSU sales representatives before
CLK In
Digital Data Interface
ordering.The information and circuit diagrams in this document are presented “as is”, no license is granted by implication or otherwise.
Analog Output Scaling
Analog Output Pins
TWOC
0
1
Table 9: Digital Data Format Control Pin Function
Figure 3 CLK In to Analog Out Timing
Digital Data Format
t
Unsigned Binary
pd
2’s Complement
OP
should be set to 20mA, and the digital data
Production
OP
) by increasing R
Page 13 of 44
OP
ref
).
.