DEMO9S08QB8 Freescale Semiconductor, DEMO9S08QB8 Datasheet - Page 13

• Manufacturer Part Number: DEMO9S08QB8
• Description: BOARD DEMO FOR 9S08 QB MCU
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S08QB8

• Contents: Board, Cable
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08QB
• Kit Contents: Board
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08QB8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.3.2
3.4
DEMO9S08QB8 User Manual
Note:
Quick Startup
Installing P&E Resources
After installation of CodeWarrior 6.2, it is also required that you install the
S08QB8 service pack.
Use the DEMOQE Resources DVD-ROM to access and install P&E resources
for the DEMO9S08QB8. These materials are not required for operation. The
support materials contained on the DEMOQE Resources DVD-ROM are
listed in Section 1.4 - Recommended Materials On DEMO9S08QB8
Resources CD.
Only a few steps are required to get the DEMO9S08QB8 up and running:
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Make sure that both CodeWarrior Development Studio v.6.2 and
the S08QB8 service pack are installed on your PC. Additional
information regarding CodeWarrior can be found at
www.freescale.com.
Remove the DEMO9S08QB8 demonstration board from its anti-
static pouch. The green MC9S08QB8 daughter card should be
plugged into the header on the base board.
Connect the USB cable from your computer to the
DEMO9S08QB8 demonstration board. Depending on your
operating system, you may need to follow steps to install the USB
driver from the DEMOQE Resources DVD-ROM. Once the USB
cable is connected properly the green USB LED on the
DEMO9S08QB8 should illuminate.
Turn on the DEMO9S08QB8 power switch (K6). The red Power
LED should illuminate.
PTC0 will output a fixed 75% duty cycle pulse width modulation
(PWM) signal. LEDs PTC0 to PTC2 remain on.
First press the button labeled “PTA2.” The buzzer will sound and
and the PTC0 PWM duty cycle will change to 25%. LEDs PTC0,
PTC1,and PTC3 are illuminated.
potentiometer. The light intensity of LED PTC0 and the tone of the
Press the PTA2 button a second time. the buzzer will sound again
Press the PTA2 button a third time, and then rotate the
9