M30290T2-CPE-HP Renesas Electronics America, M30290T2-CPE-HP Datasheet - Page 26

• Manufacturer Part Number: M30290T2-CPE-HP
• Description: EMULATOR COMPACT FOR M16C/TINY
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30290T2-CPE-HP

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/Tiny
• For Use With: M30290T2-CPE - EMULATOR COMPACT M16C/26A/28/29
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30290T2-CPE User’s Manual
2.6 Turning ON the Power
2.6.1 MCU Power Supply Source Selection Jumper/MCU Power Supply Voltage Selection Jumper
Set the MCU power supply source selection jumper and the MCU power supply voltage selection jumper of the emulator
according to conditions of use.
Figure 2.6 Jumper switch locations
These are the jumper switches to select power supply to the MCU and its power voltage. As shown in Table 2.2 below, set the
switch according to the connection to the user system.
Table 2.2 Setting jumper switches
REJ10J0494-0200 Rev.2.00 July 16, 2005
Note on Jumper Switch Settings:
the user system
Not connected
Connection to
Connected
POWER
POWER
CLOCK
LED1
RESET
SAFE
Always shut OFF the emulator before changing the setting of the jumper switches, and connecting the cable.
Otherwise the internal circuit may cause a break.
RUN
LED3
LED6
LED2
SAFE
RUN
POWER
POWER
CLOCK
RESET
COMPACT EMULATOR
MCU power supply
source selection
jumper (JP1)
EXT
STATUS
INT
SYSTEM
STATUS
TARGET
COMPACT EMULATOR
M30290T2-CPE
MADE IN JAPAN
MADE
MCU power supply
voltage selection
5.0V
jumper (JP2)
POWER USB
Invalid
3.3 V
5.0 V
CAUTION
JP1
JP2
EXT
5.0V
3.3V
INT
Supplied from the emulator. The MCU operating
voltage is 3.3 V.
Supplied from the emulator. The MCU operating
voltage is 5.0 V.
Supplied from the user system. This emulator
consumes max. 500 mA of electrical current from the
user system.
SW1
JP2: MCU power supply volatge
JP1: MCU power supply source
Description
(factory-setting: 5.0V
selection jumper
(factory-setting: INT
selection jumper
Page 24 of 86
2. Setup