M306K9T2-CPE Renesas Electronics America, M306K9T2-CPE Datasheet - Page 11
![no-image](/images/manufacturer_photos/0/5/560/renesas_electronics_america_sml.jpg)
M306K9T2-CPE
Manufacturer Part Number
M306K9T2-CPE
Description
M-SUPPORT TOOL
Manufacturer
Renesas Electronics America
Type
In Circuit Debuggerr
Specifications of M306K9T2-CPE
Contents
Compact Emulator, IDE, Assembler and Linker
For Use With/related Products
M306K9
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Warning for Handling This Product:
Warning for Installation:
Warning for Use Environment:
Cautions to Be Taken for Turning On the Power:
Cautions to Be Taken for Handling This Product:
Cautions to Be Taken for System Malfunctions
• Do not disassemble or modify this product. Disassembling or modifying this product can cause
• Do not set this product in water or areas of high humidity. Spilling water or some other liquid into
• This equipment is to be used in an environment with a maximum ambient temperature of 35°C. Care
• Turn on the power of the emulator and target system as simultaneously as possible.
• Turn off the power of the emulator and target system as simultaneously as possible.
• Do not leave either the emulator or target system powered on, because of leakage current the
• When turning on the power again after shutting off the power, wait about 10 seconds.
• Use caution when handling the main unit. Be careful not to apply a mechanical shock.
• Do not touch the connector pins of the emulator main unit and the target MCU connector pins
• Do not pull the compact emulator main unit by the USB interface cable for connecting to the target
• Do not use inch-size screws for this equipment. The screws used in this equipment are all ISO
• If the emulator malfunctions because of interference like external noise, do the following to remedy
damage.
the main unit can cause an unrepairable damage.
should be taken that this temperature is not exceeded.
internal circuits may be damaged.
directly. Static electricity may damage the internal circuits.
system. The cable may cause a break.
(meter-size) type screws. When replacing screws, use same type screws as equipped before.
the trouble.
(1) Press the RESET button on the emulator upper board.
(2) If normal operation is not restored after step (1), shut OFF the emulator once and then
reactivate it.
WARNING
CAUTION
( 9 / 56 )