R0E5212DACPE00 Renesas Electronics America, R0E5212DACPE00 Datasheet - Page 24

• Manufacturer Part Number: R0E5212DACPE00
• Description: EMULATOR DEV COMPACT R8C-2C/D
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E5212DACPE00

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: R8C/2C, R8C/2D
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

R0E521000CPE00 User’s Manual
2.3 Changing Settings
2.3.1 MCU Power Supply Source Selection Jumper/MCU Power Supply Voltage Selection Jumper
Set the MCU power supply source selection jumper and the MCU power supply voltage selection jumper of the emulator
according to conditions of use (see Figure 2.2).
Figure 2.2 Jumper switch locations
These are the jumper switches to select power supply to the MCU and its power voltage. As shown in Table 2.1 below, set the
switch according to the connection to the user system.
Table 2.1 Setting jumper switches
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 22 of 92
Note on Changing Jumper Switch Settings:
the user system
Not connected
Connection to
Connected
POWER
POWER
CLOCK
RESET
LED1
SAFE
RUN
Always shut OFF the emulator before changing the setting of the jumper switches. Otherwise the internal circuit
may cause a break.
LED3
LED6
LED2
COMPACT EMULATOR
POWER
POWER
SAFE
CLOCK
RESET
RUN
MCU power supply
source selection
COMPACT EMULATOR
R0E521000CPE00
jumper (JP1)
SYSTEM
STATUS
TARGET
STATUS
MADE IN JAPAN
EXT
INT
MADE
MCU power supply
5.0V
POWER USB
-
voltage selection
jumper (JP2)
Invalid
3.3 V
5.0 V
CAUTION
+
5.0V
3.3V
EXT
JP2
JP1
INT
SW1
Supplied from the emulator. The MCU operating
voltage is 3.3 V.
Supplied from the emulator. The MCU operating
voltage is 5.0 V.
Supplied from the user system. This emulator
consumes max. 500 mA of electrical current from the
user system.
JP2: MCU power supply voltage
JP1: MCU power supply source
selection jumper
(factory-setting: 5.0V)
selection jumper
(factory-setting: INT)
Description
2. Setup