R0E5212DACPE00 Renesas Electronics America, R0E5212DACPE00 Datasheet - Page 35

• Manufacturer Part Number: R0E5212DACPE00
• Description: EMULATOR DEV COMPACT R8C-2C/D
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E5212DACPE00

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: R8C/2C, R8C/2D
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

R0E521000CPE00 User’s Manual
2.7.4 LED Display When the Emulator Starts Up Normally
After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.14
shows the positions of the emulator status LEDs.
Figure 2.14 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.15 when the user system is not connected and as shown in Figure 2.16 when a
user system is connected. After turning on the power, the LED4 (CLOCK) and LED5 (RESET) light on. Check the
target status LEDs display normally after starting up the emulator debugger.
When the target status LEDs do not display as shown in Figures 2.15 to 2.17, refer to “5. Troubleshooting” (page 84).
Figure 2.15 Target status LEDs display when the emulator starts up normally (when user system not connected)
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 33 of 92
System status LEDs
Target status LEDs
POWER
CLOCK
RESET
RUN
After turning the power ON.
The POWER LED does not light.
LED3
LED4
LED5
LED6
When the user system NOT
connected:
POWER
POWER
LED1
CLOCK
RESET
SAFE
RUN
LED3
LED6
LED2
POWER
SAFE
POWER
CLOCK
RESET
RUN
COMPACT EMULATOR
R0E521000CPE00
POWER
COMPACT EMULATOR
CLOCK
RESET
SYSTEM
STATUS
TARGET
STATUS
RUN
After starting up the
emulator debugger.
MADE IN JAPAN
MADE
LED 3
LED4
LED5
LED6
J1
5.0V
POWER USB
-
J2
+
5.0V
3.3V
EXT
JP2
JP1
INT
: ON
: OFF
SW1
2. Setup