HS0005KCU04H Renesas Electronics America, HS0005KCU04H Datasheet - Page 37

• Manufacturer Part Number: HS0005KCU04H
• Description: EMULATOR E10A-USB SUPERH RISC
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU04H

• Contents: Emulation Module
• For Use With/related Products: SH7205, SH7265
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

(5) Changes the trace settings during user program execution.
2.3
The emulator has the following three break functions.
(1) Hardware break function
Note: In some devices to be debugged, hardware break settings can be changed during user
(2) PC break function (BREAKPOINT)
(3) Forced break function
2.4
The emulator has a following performance measurement function.
2.4.1
This function applies a counter in the device to measure the number of cycles from one specified
condition being satisfied until a next specified condition is satisfied.
Not only the number of cycles but also various items such as the number of cache misses or of
TLB misses can be measured according to the supported devices.
In some devices to be debugged, trace settings can be changed during user program execution.
For details on the specifications of each product, refer to the online help.
Uses a break controller incorporated in the device.
The access address, instruction fetch address, data, or bus cycle condition can be set. The
logical address is the address condition.
This function can be also set from the [Event] column in the [Editor] or [Disassembly] window.
For the setting, refer to section 5.3, Downloading a Program.
Breaks when the dedicated instruction at the specified address that has been replaced is
executed. This function cannot be set at a place other than RAM or internal flash memory area
since a memory write occurs.
It can also be set when the [S/W breakpoint] column for the line to be set is double-clicked in
the [Editor] or [Disassembly] window.
Forcibly breaks the user program.
program execution. For details on the specifications of each product, refer to the online
help.
Break Function
Performance Measurement Function
Function for Measuring the Number of Cycles from Point to Point
Rev. 2.00 Nov. 19, 2009 Page 15 of 294
REJ10J1766-0200