M68MULTILINK08 Freescale Semiconductor, M68MULTILINK08 Datasheet - Page 25

• Manufacturer Part Number: M68MULTILINK08
• Description: PROGRAMMER LOW COST 68HC908
• Manufacturer: Freescale Semiconductor
• Type: In Circuit Debuggerr

Specifications of M68MULTILINK08

• Contents: In-Circuit Programmer, Emulator, Debugger, CodeWarrior Dev. Studio for HC08, Power Supply
• For Use With/related Products: 68HC908 FLASH MCUs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

P&E
3.22
MON08 Multilink User Manual
68HC908MR16/32
Microcomputer
Systems, Inc.
should pull down PORTB1 with a 4.7K Ohm resistor.
Please note that the MR4/8 is not currently supported by the MON08
CYCLONE.
The target GND is connected to the Pin 2 of the target MON08 Header.
The target RESET line is directly connected to the Pin 4 of the target MON08
Header.
Alternatively, the user may pull up the RESET line to target VDD. In which
case the user does not need to connect this signal to the target MON08 Header.
The target IRQ line is directly connected to the Pin 6 of the target MON08
Header.
PORTA0 from the target processor is connected to the target MON08 Header
Pin 8, acting as the communications line. The MON08 MULTILINK pulls up
this signal with a 10K Ohm resistor to the target VDD.
PORTA7, PORTC2, PORTC3 and PORTC4 are used for entering monitor
mode. By default the user may directly bring these signals out to the target
MON08 Header.
Alternatively, the user may pull up PORTC3, pull down PORTA7 and
PORTC4, and pull up/down PORTC2 for clock division. In which case the
user does not need to connect these signals to the target MON08 Header.
Freescale Semiconductor, Inc.
Figure 3-22: 68HC908MR16/32 Family MON08 Pinout
For More Information On This Product,
Go to: www.freescale.com
MON08 MULTILINK
25