M68MULTILINK08 Freescale Semiconductor, M68MULTILINK08 Datasheet - Page 6

• Manufacturer Part Number: M68MULTILINK08
• Description: PROGRAMMER LOW COST 68HC908
• Manufacturer: Freescale Semiconductor
• Type: In Circuit Debuggerr

Specifications of M68MULTILINK08

• Contents: In-Circuit Programmer, Emulator, Debugger, CodeWarrior Dev. Studio for HC08, Power Supply
• For Use With/related Products: 68HC908 FLASH MCUs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

MON08 MULTILINK
2.3
6
Target MON08 Connector
Please note that if the target already uses an oscillator as its clock, the MON08
MULTILINK will NOT be able to overdrive it. The clock should have
sufficient drive to be used with a target system even if the target system has an
RC circuit or crystal connected.
The MON08 MULTILINK requires the target to have a standard 16-position
0.100-inch pitch dual row 0.025-inch square header. The mechanical drawing
is shown in Figure 2-1.
The MON08 Connector adopts the standard pin-out from MON08 debugging
(as used on different ICS boards) with some modifications. The general pin-out
is as follows:
Freescale Semiconductor, Inc.
Figure 2-1: 16-Pin Header Mechanical Drawing
For More Information On This Product,
PIN11 - NC
PIN13 - OSC
PIN15 - Vout
PIN 1 - NC
PIN 3 - NC
PIN 5 - NC
PIN 7 - NC
PIN 9 - NC
Go to: www.freescale.com
GND
RST
IRQ
MON4 - PIN 8
MON5 - PIN10
MON6 - PIN12
MON7 - PIN14
MON8 - PIN16
- PIN 2
- PIN 4
- PIN 6
P&E
MON08 Multilink User Manual
Microcomputer
Systems, Inc.