M68MULTILINK08 Freescale Semiconductor, M68MULTILINK08 Datasheet - Page 9

• Manufacturer Part Number: M68MULTILINK08
• Description: PROGRAMMER LOW COST 68HC908
• Manufacturer: Freescale Semiconductor
• Type: In Circuit Debuggerr

Specifications of M68MULTILINK08

• Contents: In-Circuit Programmer, Emulator, Debugger, CodeWarrior Dev. Studio for HC08, Power Supply
• For Use With/related Products: 68HC908 FLASH MCUs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

P&E
3
3.1
MON08 Multilink User Manual
TARGET MON08 HEADER PINOUTS
68HC908AB
Microcomputer
Systems, Inc.
following: SPP, Normal, Standard, Output Only, Unidirectional, AT. Try to
avoid ECP, EPP, or PS/2 bi-directional.
If a parallel port extension cable is used, the parallel cable connecting the PC
parallel port and the MON08 MULTILINK cable must be IEEE1284
compliant.
This chapter details the MON08 connector signals according to the individual
target MCU types.
The target GND is connected to the Pin 2 of the target MON08 Header.
The target RESET line is directly connected to the Pin 4 of the target MON08
Header.
Alternatively, the user may pull up the RESET line to target VDD. In which
case the user does not need to connect this signal to the target MON08 Header.
The target IRQ line is directly connected to the Pin 6 of the target MON08
Header.
PORTA0 from the target processor is connected to the target MON08 Header
Pin 10, acting as the communications line. The MON08 MULTILINK pulls up
this signal with a 10K Ohm resistor to the target VDD.
PORTC0, PORTC1 and PORTC3 are used for entering monitor mode. By
default the user may directly bring these signals out to the target MON08
Header.
Alternatively, the user may pull up PORTC0 and pull down PORTC1, and pull
up/down PORTC3 for clock division. In which case the user does not need to
connect these signals to the target MON08 Header.
Freescale Semiconductor, Inc.
For More Information On This Product,
Figure 3-1: 68HC908AB Family MON08 Pinout
Go to: www.freescale.com
MON08 MULTILINK
9