MC56F8323EVM Freescale Semiconductor, MC56F8323EVM Datasheet - Page 26

• Manufacturer Part Number: MC56F8323EVM
• Description: KIT EVALUATION FOR MC56F8323
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of MC56F8323EVM

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC56F8322 and MC56F8323
• Data Bus Width: 16 bit
• Interface Type: RS-232
• For Use With/related Products: MC56F8322, MC56F8323
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

26
Signal Name
(GPIOA5)
FAULTA0
(GPIOA6)
FAULTA1
(GPIOA7)
FAULTA2
(GPIOA8)
(SCLK1)
PWMA5
Table 2-2 Signal and Package Information for the 64-Pin LQFP
Pin No.
10
13
14
15
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Output
Output
Output
Output
Output
Output
Input/
Input/
Input/
Input/
Input/
Type
Input
Input
Input
State During
disabled,
pull-up is
output is
In reset,
enabled
Reset
56F8323 Technical Data, Rev. 17
Input
Input
Input
PWMA5 — This is one of six PWMA output pins.
SPI 1 Serial Clock — In the master mode, this pin serves as an
output, clocking slaved listeners. In slave mode, this pin serves as
the data clock input. A Schmitt trigger input is used for noise
immunity.
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
In the 56F8323, the default state after reset is PWMA5.
In the 56F8123, the default state is not one of the functions offered
and must be reconfigured.
FAULTA0 — This fault input pin is used for disabling selected
PWMA outputs in cases where fault conditions originate off-chip.
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
In the 56F8323, the default state after reset is FAULTA0.
In the 56F8123, the default state is not one of the functions offered
and must be reconfigured.
FAULTA1 — This fault input pin is used for disabling selected
PWMA outputs in cases where fault conditions originate off-chip.
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
In the 56F8323, the default state after reset is FAULTA1.
In the 56F8123, the default state is not one of the functions offered
and must be reconfigured.
FAULTA2 — This fault input pin is used for disabling selected
PWMA outputs in cases where fault conditions originate off-chip.
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
In the 56F8323, the default state after reset is FAULTA2.
In the 56F8123, the default state is not one of the functions offered
and must be reconfigured.
Signal Description
Freescale Semiconductor
Preliminary